片语

Crystallization peak temperature结晶峰温度

Crystallization onset temperature结晶起始温度

crystallization at low temperature低温晶化

crystallization melting temperature结晶熔点

solidification point[物] 凝固点；结晶温度

true crystallization temperature真实结晶温度

crystallization at room temperature常温结晶

melt crystallization temperature熔融结晶温度

crystallization point结晶点；结晶温度

cooling crystallization peak temperature冷结晶峰温

cold crystallization temperature冷结晶温度

英汉例句

• the method overcomes the shortcoming of grain growing above the initial crystallization temperature in annealing method, successfully preparing nano-crystalline material of very small grain .

  该方法避免了传统的退火法在晶化温度以上晶粒长大这一缺点，成功制备出晶粒极细小的纳米材料。

• but compared to as-quenched samples, the glass transition temperature, crystallization temperature and crystallization peak temperature have same changes.

  但与淬态试样相比，玻璃转变温度、晶化温度及晶化峰值温度存在一定的变化。

• the results show that the crystallization temperature decreases with the increase of cold pressure rate.

  结果表明，随冷轧压加率的提高，再结晶温度降低。

• the dsc results showed both the melting temperature and crystallization temperature of the grafting products were decreased.

  dsc研究表明辐照接枝产物的熔融温度和结晶温度均降低。

• the harm of crystallization temperature returning in palm oil dry fractionation was introduced and the reasons were analyzed.

  简要说明了棕榈油干式分提工艺结晶回温的害处，并详细分析了回温的原因。

• the results of dsc showed that pet/mmt modified by ipa increased the cold crystallization temperature and decreased the melt crystallization temperature of pet/mmt.

  dsc扫描实验表明：加入ipa共聚后，pet／mmt的冷结晶温度提高、过北京化工大学硕士论文冷温度降低，i以改性pet/mmt的结晶速率比pet/mmt慢。

• the best peak firing temperature was existed, which was between the softening temperature and the peak crystallization temperature, and near the incipient crystallization temperature of the glass.

  电阻浆料存在最佳峰值烧成温度。 理论分析表明，最佳峰值烧成温度应在软化点与峰值析晶温度之间，靠近起始析晶温度。

• they and the steel wire and solid-phase liquidus temperature and the size of the crystallization temperature range.

  它们与钢的固相线和液相线温度的高低及结晶温度区间的大小有关。

• the results show that the carbon nanofiber can heighten the crystallization temperature of polypropylene and lower its crystallization rate and degree of crystallization in small extent.

  结果表明：纳米碳纤维可提高pp的结晶温度，但略降低其结晶速率和结晶度。

• the results showed that solid grafted ema could play a role of heterogeneous nucleating agent in pp, raising the crystallization temperature and crystallinity of pp.

  结果表明：固相接枝ema对pp的结晶起到异相成核的作用，提高了pp的结晶温度和结晶度；

• it is shown that the crystallization temperature and crystal size distribution increase with reduce of the feed ratio.

  结果表明随着物料配比的减小，结晶温度点和结晶晶体的粒度呈现明显的下降趋势；

• crystallization temperature rised with decreasing viscosity.

  结晶温度随着粘度的降低而升高。

• solidus and liquidus temperatures of the rocks and relationship between crystallinity and crystallization temperature have been determined.

  确定了巖石固相线与液相线的温度，巖石结晶程度与温度的关系。

• the si—oh bond, impurity and phase interface are the important factors for the crystallization temperature of the quartz fiber to be lower than that of the quartz glass.

  oh键、杂质以及界面等因素是石英纤维析晶温度低于石英玻璃的主要原因。

• the results show that supercritical co2 depresses the crystallization temperature of bapc.

  结果表明，超临界co2显着降低bapc的结晶温度；

• the influence of melting temperature, melting time, crystallization temperature and cooling mode on form and size of nylon 66 was studied.

  研究了熔融温度、熔融时间、冷却方式及结晶温度对尼龙66球晶形态和大小的影响。

• the study indicates that synthetic conditions such as crystallization temperature and time , the type and composition of organic templates, could effect on sapo-11 molecular sieves synthesis greatly.

  研究表明，合成条件，如晶化温度和时间、有机模板剂的类型和组成等，都对sapo-11分子筛的合成有很大影响。

• the effect of fe-based amorphous alloys average electron consistence on crystallization temperature was investigated.

  研究了铁基非晶合金平均电子浓度对晶化温度的影响。

• it has been found that as the heating time increases, the crystallization temperature of the amorphous alloy will decrease.

  该非晶合金出现晶化的温度随热处理时间的增长而降低。

• crystallization temperature of the as-quenched alloys were measured by dsc.

  用dsc法测定了制备态合金的晶化温度。

• the blending composition, temperature and time have a dramatic effect on the cold crystallization temperature (tc) increases and the melting tmperature (t m).

  冷结晶温度和熔融温度与共混比例、共混时间、温度等因素密切有关。