inclination angle中文,inclination angle的意思,inclination angle翻译及用法

2025-10-31 20:27 浏览次数 8

inclination angle

英[ˌɪnkləˈneɪʃən ˈæŋɡl]美[ˌɪnkləˈneʃən ˈæŋɡəl]

倾斜角,[数] 倾角

inclination angle 片语

片语

Maximum Stable Inclination Angle最大稳定倾斜角

inclined angle倾斜角;夹角

inclination angle of blowpipe割倾角

Range of Inclination Angle托臂倾角范围

joint inclination angle节理倾角

finger inclination angle[船]

Front inclination Angle前倾角

high inclination-angle大倾角

trajectory inclination angle弹道倾角

skew angle倾斜角;斜交角

port inclination angle孔倾角

inclination angle 例句

英汉例句

  • The invented device is: inclination angle adjustable off-centering reducing double-roller cast rolling-thermal tandem rolling- cutting-coiling production line.

    该设备是:铸嘴倾角可调的偏心异径双辊铸轧―热连轧―剪切―卷取生产线。

  • The effects of cross-section, inclination angle of fiber bundle and the volume fraction of resin rich area on local area equivalent stiffness were studied.

    通过算例研究了纤维束截面、纤维束起伏角以及富树脂区体积分数等细观参数对局部区域等效刚度的影响。

  • When the inclination angle of a side nozzle is 0, 30,45 and 60 degrees, the eddying flow of the bottom hole vortex device will cause rotation at the bottom hole, affecting on the jet from bit nozzles.

    侧喷嘴倾斜角度在0度、30度、45度和60度情况下,由于井底涡旋器的旋流作用,导致井底产生旋转,对鉆头喷嘴射流产生了影响,以致在45度时出现压力损失最小的情况;

  • The causes of increasing yield and photosynthesis traits in canopies of erectophile-type maize are discussed. Two quantitative parameters, leaf inclination angle and …

    文中分析了紧凑型玉米群体结构的光合生产特性和株型的增产原因。

  • For harvesting lodging maize, the inclination angle of the ear snapping unit relative to the ground is reduced, and a front plant holding plate of a plant holding device is lowered toward the ground.

    收获倒伏玉米时,先将摘穗装置与地面的倾斜角度调小, 将扶禾装置的前扶禾板相对地面调低。

  • The result shows that laser induced plasma and weld geometry are sensitive to side nozzle height, its inclination angle and side gas flow rate;

    结果表明,侧吹喷嘴高度和侧吹流速的变化对光致等离子体行为和焊缝形貌有显着的影响;

  • The effects of tool's inclination angle on chip formation and the temperature fields, as well as the cutting forces, back forces and feed forces are discussed.

    通过三维切削模拟可以获得在不同刃倾角精密切削过程的条件下切屑形状、切削力和切削温度场的分布情况。

相关热词