英语释义

• the amount of magnetic flux in a unit area perpendicular to the direction of magnetic flow

片语

Magnetic Flux Density Simulation通过磁通量密度分析

Magnetic Flux Density Distribution磁通密度分布

residuwis magnetic flux density渣滓磁通密度

normal magnetic flux density正常磁感应密度

intensity of magnetic flux磁通密度

saturation magnetic flux density饱和磁通密度

magnetic c flux density磁感应密度

Magnetic flux density B磁通密度

intensity of magnetization磁感应强度

remanent magnetic flux density残留磁束密度

perpendicular magnetic flux density正交磁通密度

英汉例句

• using the proposed model, the relation between the magnetic flux density in the air of the giant magnetostrictive force sensor and the value of force applied on the magnetostrictive rod is calculated.

  应用该模型计算了超磁致伸缩力传感器空气隙中的磁感应强度和磁致伸缩棒上施加力的关系，并与实验值进行了比较。

• the magnetic flux density on the crack tip in a metal pipeline was studied by numerical simulation method.

  用数值模拟方法研究了金属管道裂纹尖端磁通量密度的分布情况。

• on the center surface of ems, magnetic flux density in the corner is significantly greater than that in the center.

  钢液中心面的磁感应强度在角部要明显大于中心。

• an empirical formula describing the dependence of the power of hysteresis loss on frequency, magnetic flux density and temperature was derived.

  得出磁滞损耗功率与频率、磁通密度及温度的经验公式。

• the relationship between average value of magnetic flux density in annular channels and excitation electrical currents are experimentally obtained.

  通过实验方法研究了剪切通道平均磁通密度与励磁电流的关系；

• in calculating the magnetic flux density b between two blocks of parallel block capacitors, there are two common solutions, one of which is not correct.

  在计算一平行板电容器的两板间磁感应强度b时，有常见的两种解法，其中一种常见解法是错误的。

• if a magnetic flux density is larger than threshold bop, do is turned to sink and dob is turned to drive.

  如果磁通密度大于阈值波普，do是转向下沉和出生日期是转向驱动器。

• this paper has studied the influences of chemical compositions and hot rolling temperature on mechanical properties and magnetic flux density of magnetic yoke sheet.

  本文研究了钢的主要成分，轧制温度对磁轭薄板力学性能和磁通密度的影响。

• relationship between mrf' s yield stress and magnetic flux density, the shear stress and magnetic flux density and shears tress and shear rate were investigated.

  研究了流体的屈服应力与磁场的关系，剪切应力与磁场以及剪切速率的关系。

• the magnetic fluid sealing pressure is mainly related to the magnetic flux density of the magnetic gap, and also related to the structure.

  磁流体密封压力主要由间隙的磁通密度决定，结构参数对密封压力也有影响。

• interior permanent magnet(ipm)synchronous motors enhance performance via rotor- shaping designs that help increase magnetic flux density and maintain high torque at higher speeds.

  内置永磁体同步电机通过改进转子设计提高了磁通量密度，实现了高转速下的高扭矩，大大提高了电机的性能。

• the distribution of the magnetic flux density in the magnetic field generator which provided traveling magnetic field have been studied.

  研究了移动磁场发生器的电磁特征及磁场空间分布规律；

• the increase in magnetic flux density no longer has effect on particle aggregation after particles are saturatedly magnetized.

  在粒子达到饱和磁化后，磁感应强度的增大对聚并无影响；

• in the radial of ems, magnetic flux density and electromagnetic force decrease with the increase of frequency, the influence of frequency on tangential velocity is very little.

  沿搅拌器中心径向，磁感应强度和电磁力随频率增加而减小，频率对切向流速的影响不大。

• the methods to reduce transformer noise by reducing magnetic flux density and optimizing structure design are discussed under saving transformer material cost.

  讨论了通过降低磁通密度和优化结构设计，在节省变压器材料成本前提下降低变压器噪声的方法。

• by controlling hot rolling temperature and cooling rate, the strength of the steel can be increased while the magnetic flux density will not be affected.

  通过控制轧制、控制冷却，可提高钢的强度、而不损害钢的磁通密度。

• the influence of frequency on magnetic flux density and lorentz force in melt is studied.

  研究了磁场频率对金属熔体内磁感应强度及洛侖兹力的影响。

• the magnetic flux density is uniform near the center of coil, therefore, the meniscus level in mold should locates between the coil center and the top of mold in casting operation.

  在线圈中心位置附近的磁感应强度分布较均匀，实际浇铸过程中，应将液面控制在线圈高度中心与线圈顶端位置之间。

• fbg-based air gap magnetic flux density online measurement system is established, which realizes air gap, rotor speed and coil current adjustments to simulate mb working states.

  构建了磁力轴承fbg气隙磁通密度在线测量系统，实现气隙、转速、线圈电流的调节，模拟磁力轴承的工作状态。

• the simulation model of experimental motor y2-90s-4 was built, the distribution of magnetic field lines, magnetic flux density and the electromagnetic force of normal motor was calculated.

  建立了实验电机y2-90s-4的仿真模型，仿真计算了电机在正常运行情况下的磁力线分布、磁通量密度以及电磁力情况；

• calculations and experiments are carried out on both magnetic flux density and eddy current loss of the non-magnetic steel plate and of the coil in this model.

  对该模型低磁钢板及线圈的磁通密度和涡流损耗进行了试验与计算分析，得到了一些有价值的试验和分析结果，为磁场计算和三维涡流损耗分析方法提供了验证手段。

• the finite element analysis of the magnetic field for a mr valve of the damper was done via ansys package, and the magnetic flux density of mr valve was obtained.

  在ansys软件中建立了阻尼器流口的电磁有限元模型，求得了平行板流口间磁流变流体（mr流体）的磁通密度。