片语

Addendum modification coefficient J径向变位系数

soil modification coefficient土壤修正系数

modification coefficient d value修正系数d值

introducing a modification coefficient引入修正系数

the modification coefficient修正系数

Centre distance modification coefficient中心距变位系数

temperature modification coefficient温度校正系数

modification n coefficient变位系数

gear modification coefficient齿轮变位系数

英汉例句

• these problems can be solved by increasing the modification coefficient of small vertical cutting gear, increasing the number of gear teeth and restored the height of the bed saddle and so on.

  采用增大纵向走刀小齿轮的变位系数、增加小齿轮齿数、恢复床鞍高度等方法可解决上述问题。

• a method of calculating and selecting modification coefficient of the internal gear with less teeth difference is presented.

  介绍了一种适用于少齿差内啮合行星齿轮变位系数的计算及选取方法。

• at same time it discusses the subjective influence on risk measurement and gives the subjective modification coefficient of risk.

  对个体因素对风险的影响进行了初步研究，并提出了相应的个体修正系数及其计算方法。

• the method for determining the modification coefficient of wave force in overtopping under irregular wave action was also discus- sed. some of the calculation results were verified dy the experiments.

  文中还对不规则波情况下越浪修正系数的形式进行了探讨，并对部分计算结果进行了实验验证。

• the approach presented to achieve the modification coefficient and the minimum tooth number is applicable to the silent chain mechanism with all kinds of pitches.

  求解变位系数和最小齿数的方法可适用于所有节距的齿形链机构。

• the method for determining the modification coefficient of wave force in overtopping under irregular wave action was also discus- sed. some of the calculation results were v…

  文中还对不规则波情况下越浪修正系数的形式进行了探讨，并对部分计算结果进行了实验验证。

• the modification coefficient of big modified gears is designed by visual method, this method is practical and re-liable, it is suitable for engineering application.

  采用计算机可视化方法设计大变位齿轮变位系数，此方法实用、可靠，适合工程应用。

• the method and procedure of measuring and calculating involute spur gear geometrical parameters such as tip diameter, module, modification coefficient and pressure angle were shown in this paper.

  本文阐述了渐开线直齿圆柱齿轮顶圆直径及齿轮模数、变位系数和压力角等参数的确定方法和步骤。

• this test was to simulate the actual thermohydraulic condition of the reactor core to obtain modification coefficient that could be directly used in the core of u-h-zr reactor.

  试验中模拟堆内实际热工水力工况，求得的校正系数可直接在铀氢锆堆内应用。