片语

solid-particle concentration局部颗粒浓度

S solid particle固体颗粒

solid crystal particle固体结晶颗粒

solid impurity particle渣颗粒

Solid Particle Erode固体粒子腐蚀

solid particle motion固体颗粒运动

solid particle content固体微粒含量

solid d particle固体微粒

英汉例句

• The applicable formulae of pressure drop in the dilute flow for solid particle through a vertical pipe are developed.

  文中提出了固体粒子稀相流垂直管内适用的压力损失计算式。

• The sizes of filler and abrasive have influence on the solid particle erosion of coating under the given condition, the size of filler be of weak influence on the slurry erosion.

  填料粒度和磨料粒度都对涂层的气固沖蚀磨损有影响，但在给定的试验条件下，填料粒度对涂层的浆体沖蚀磨损影响甚微。

• Erosion of the blade by the solid particle of the smoke and gas is the major problem of axial flow fan, which may make axial flow fan reduce power and even stop working.

  轴流式引风机的失效形式主要表现为烟气中的固体颗粒对轴流式引风机叶片的沖蚀磨损，轴流式引风机叶片的失效会导致出力效率降低甚至停机。

• The wear properties of antiwear adhesive coatings under solid particle erosion and slurry erosion condition were studied in this paper.

  本文对气固沖蚀和浆体沖蚀条件下耐磨环氧胶粘涂层的磨损特性进行了研究。

• But such as short circuit flow, up ash loop, re-entrainment exists and so on phenomenon, made the solid particle couldn「t be separated efficiently, so reduced separation efficiency of the cyclone.

  但是旋风除尘器中存在的短路流，上灰环，二次扬尘等现象，使得固体颗粒不能被完全有效分离，降低了除尘器的分离效率。

• The results showed that the solid particle became finer, more homogeneous and rounder with the decrease of temperature or the increase of shearing rate.

  研究表明：适量提高剪切速率或降低温度，半固态组织的固相颗粒会变得细小、均匀和圆整。

• Based on the former research work of the authors, the resistance of different solid particle suspension flow in a vertical straight pipe is analysed and the experiment study is done.

  在作者工作的基础上，对不同的固体粒子在气流悬浮下垂直管内流动阻力进行了分析和实验研究。

• In the model the exit area ratio, solid particle mass ratio, fuel enthalpy of combustion, jet gas molecular weight, chamber stagnation temperature, flight Math number etc. have been considered.

  在该模型中考虑了底排出口面积比，排气固相颗粒质量比，燃料热值，燃气分子量，燃烧室总温，飞行马赫数等因素。

• Solid particle erosion may damage the turbogenerator sets. Minimizing particles, wear-proof covered layer and by pass are three effective approaches for Minimizing solid particle erosion.

  固体颗粒磨蚀对汽轮机的危害不可忽视。减少颗粒、防磨镀层和将颗粒引向旁路是目前采用的三种解决方法。

• Fluidized bed drier enjoys advantages of even solid particle mixing and large heat and mass transfer area of gas and solid phase.

  流化床操作具有固体颗粒混合好，气固两相传热传质表面积大等优点。

• The EU calculates that the ABB solution eliminates 80 metric tons of nitrogen oxide, 60 tons of sulphur dioxide and two tons of solid particle emissions at the port each year.

  欧盟认为A BB的解决方案每年为该港口减少了80公吨的氧化氮，60吨的氧化硫以及2吨固体微粒的排放。

• It travels at 186,000 miles per second and behaves as if it were both a solid particle and a wave of energy.

  光速可达每秒钟186,000哩，而且光的传播不但是固体的粒子，又是一道能量。

• Discharge valve can be will collect the liquid and solid particle emissions, prevent the liquid flow off the downstream, the pollution downstream compressed air system.

  排放阀可以将收集的液体和固体微粒排放掉，防止液体流向下游端，污染下游端的压缩空气系统。

• In this paper, materials selection and preventing solid particle erosion measures of ultra-supercritical steam turbine」s high temperature parts are introduced.

  介绍了目前国内外关于超超临界汽轮机高温部件的材料选择及其对高温部件固粒侵蚀所采取的防止措施。

• Cyclone separator is a kind of equipment that USES rotary motion of gas-solid two-phase fluid to make the solid particle separated from the gas flow by centrifugal force.

  旋风分离器是一种利用气固两相流体的旋转运动使固体颗粒在离心力的作用下从气流中分离出来的设备。

• Installed to compressor gas-oil seperator, to remove oil and solid particle in the compressed air, supplying clean air source for compressor back.

  安装于制冷压缩机的油气分离器中，滤除压缩空气中的油雾及颗粒杂质，为压缩机后置系统提供清洁的气源。

• The effect of solid particle content in feeding liquid on phase disengagement and interfacial emulsion in copper solvent extraction is studied.

  研究了铜溶剂萃取时，萃原液中固体微粒含量对分相和界面乳化的影响。

• With the increase of solid particle content, the time of phase disengagement will be prolonged and the interfacial emulsion intensified.

  随固体微粒含量增加，分相时间延长，界面乳化程度加重。

• Two-phase flow in the cyclone separator is a process of the solid particle separation from the gas phase, while the particle movement trace is decided by the turbulence to a large extent.

  旋风分离器内部进行的是两相流运动，是气相和固体颗粒相的分离过程，而固体颗粒的运动在很大程度上取决于分离器内湍流的运动。

• It is installed in the low-pressure pipeline to filter solid particle and slimes in medium and effectively control cleanliness.

  安装于低压管路中，滤除工作介质中的固体颗粒及胶状物质，有效控制工作介质的污染度。

• On the basis of the slurry velocity distribution model, the author considered the interfering force that would influence solid particle velocity;

  在原有的非均质流速度分布模型的基础上，考虑了干涉力对固体颗粒速度的影响；

• Solid particle removal efficiency is chiefly decided by solid particle size, bubble size and the chemical properties of the solid particle surface.

  气浮法的效率主要取决于固体颗粒直径、气泡直径和固体颗粒表面的化学性质。

• In addition, the blocking of the catalyst pore by the solid particle and some organic macromoleculars which are formed in the process of reaction is another reason for the deactivation.

  同时在反应过程中产生的固体小颗粒和生成的有机大分子对催化剂孔道的阻塞也是催化剂失活的一个重要原因。

• The influences of various thin slurries with different solid particle sizes on filtration intensity are discussed.

  实验研究了不同分级粒径对过滤强度的影响。

• The optical-electrical measurement is an effective and feasible way to measure solid particle concentration and velocity in gas-solid two phase flow.

  应用光一电检测方法测量气一固两相流中固体微粒浓度、速度，是一种十分有效和可行的方法。

• The results showed that the concentration of superfine solid particle additives and test temperature and basic oils affect the friction and wear properties of PSZ-GCr15 steel pairs.

  结果表明：超细固体颗粒添加剂的用量、试验温度和基础油都影响陶瓷与钢滑动副的摩擦磨损性能。