片语

Direct Thrust Force Control直接推力控制

push factor推动因素；推力

delamination critical thrust force分层临界轴向力

thrust force by pressure盲板力

minimum electromagnetic thrust force最小电磁推力

unbalanced thrust force method不平衡推力法

radial-thrust force径向抗力

engine thrust force发动机推力

英汉例句

• secondly, the stratum structure model for analyzing overlay soil stability of tunneling was founded, and its formula for calculating level thrust force was given.

  建立了分析隧道上覆地层稳定的地层结构模型，给出了维持隧道工作面上覆地层结构稳定的水平推力计算公式；

• the ground effect increases the thrust force and efficiency.

  表面效应使机翼推力增大，推进效率提高。

• compared to single piston cylinder, it features fast action and flexibility, specially used when large thrust force or tensile force is required within short time.

  介绍了双活塞液压缸的研制及应用，与单活塞液压缸相比，它具有动作快速、灵活等优点，特别适合在需要快速提供强大推力或拉力的场合。

• this paper mainly introduces some theoretic calculations and verification tests on thrust force and acting time of piston actuator.

  从理论上计算了活塞作动器的输出推力和作功时间，通过试验进行了实验验证。

• the reliability of the value of landslide thrust force is directly relevant to its calculation method.

  滑坡推力大小的可靠性与计算方法有直接关系。

• dancing together with the consumption society, tv culture becomes thrust force through the large-scale daily information transmission one the hand.

  在消费社会与电视文化的共舞中，电视文化通过大规模的日常的信息传递、观念传播成为了消费社会发展的巨大助推力；

• imbalance thrust force method (itfm) is an original method for slope stability analysis in china, which has been widely used in the field of slope stability analysis and slope stabilization.

  不平衡推力法是我国独创的边坡稳定性分析方法 ，在滑坡的分析治理中得到了广泛应用 ，然而对其精度的分析却寥寥无几。

• particularly with taper roller bearings sufficient support of bearing rings by the adjacent parts is required due to the generated internal thrust force components.

  尤其是圆锥滚子轴承的轴承环的邻近部位足够的支持是必需的，由于所产生的内部推力组件。

• however, additional equipments are needed to monitor the thrust force .

  然而，更多的设备需要监测的推力。

• the analysis model explains the thrust force at initial stages of drilling on inclined surfaces.

  分析模型合理地解析了斜面鉆孔初期的受力现象。

• in this paper, the performance as the various forces worked on the thrust bearing and the influence of the thrust force on the radial bearings are presented.

  同时讨论了轴向磁悬浮轴承对径向轴承的影响，分析了一般情况下径向位移传感器的安装位置对轴向和径向轴承间静态和动态力耦合以及系统稳定性的影响。

• the thrust force is mainly due to the drag of the wings in the upstroke.

  平衡身体阻力的推力主要由翅膀上拍中产生的阻力提供。

• if i just look at the thrust force based on the air (yes, there are some assumptions and estimations here), i get.

  如果我只观察空气推力（是的，其中包含一些假设和估计），我得到。

• the study indicates that lost thrust force can be decreased if the pressure increases and areas in nozzle exit decrease by adjusting the geometry shape of nozzle and decreasing expansion ratio.

  计算分析显示，通过调整喷管几何形状和降低扩张比，使喷管出口处压力增大、出口面积减小，可以达到降低推力损失的目的。

• the thrust force of an airplane is produced by the propeller.

  飞机的推力由螺旋桨所产生。

• the author also finds out that to decrease the speed of shuttlechanging can decrease the thrust force of shuttle and prolong the shuttle sevice life, etc.

  并且从理论上证明了降低织机换梭速度可以显着减少推梭力，因此可合理解决速度与消耗的茅盾。

• a comparative study of the thrust force at initial stages of drilling on inclined surfaces was conducted through experiments.

  本研究通过实验，比较了斜面上鉆孔与平面上鉆孔在加工初期切削力的差异，对斜面上鉆孔加工初期的受力进行了理论分析。

• thrust force and torque are the main factors to cause the defects in machine drilling. drilling quality can be improved by setting low feed rate and high cutting speed.

  机械鉆削微小孔时，轴向力和切削扭矩是导致各种加工缺陷的主要因素，低进给量、高主轴转速可明显提高鉆削质量。

• imbalance thrust force method(itfm) is originally developed approach for slope stability analysis in china, which has been widely used in the field of landslide stability analysis.

  不平衡推力法是我国独创的边坡稳定分析方法，在滑坡稳定分析和治理中得到广泛地应用。

• direct thrust force control method for the linear motor in theory and experiment has been further studied.

  对适合直线电机直接推力控制的方法进行理论分析和实验研究。

• an impeller of a medical micro-robot utilizing the thrust force generated by the rotation of screws is studied.

  研究了一种利用螺旋旋转时产生牵引力的医用微型机器人的驱动机构。

• from the model, the effects of the dip angle and feed rate on thrust force are estimated.

  在此基础上，分析比较了进给量、斜面倾角等参数对斜面鉆孔初期受力的影响。

• the frequency of thg thrust force was analyzed.

  分析了推力的频谱，发现推力存在着较大的波动。

• the author also finds out that to decrease the speed of shuttlechanging can decrease the thrust force of shuttle and prolong the shuttles…

  并且从理论上证明了降低织机换梭速度可以显着减少推梭力，因此可合理解决速度与消耗的茅盾。