titania
n. [无化] 二氧化钛;人造金红石
2025-08-15 17:06 浏览次数 7
n. [无化] 二氧化钛;人造金红石
doped titania掺杂tio
titania fibers二氧化钛纤维
doping titania掺杂tio
Titania Medien出版者
Kronos克隆那斯(等于Cronus);二氧化钛
titanium dioxide[无化] 二氧化钛
higher titania高钛
titania fiber二氧化钛纤维
titania ceramics钛氧陶瓷
now researchers calculate the greatest of these craters might have tilted two of saturn「s moons, tethys and rhea, and uranus」s moon titania roughly 4 degrees, 7 degrees and 12 degrees, respectively.
现在研究者们计算出,最大的一个碰撞坑可能使土星的卫星,特迪斯星(tethys)和利亚(rhea),以及天王星的卫星,体坛尼亚(titania)分别倾斜了大约4度,7度和12度。
but adding nitrogen and copper to the mix shifts the preference of the titania tubes to visible light, grimes says.
但是通过加入氮气和铜,会改变二氧化钛在可见光下的催化活性。
we realized that the research on the sysnthsis and application of new layer materials in titania pillared catalyst would be promising in future.
我们认为:新层材料的研究和应用有可能是钛柱粘土研究的一个有希望的方向。
using the commercial cfd-code fluent, the simulation of the growth process of titania nanoparticle synthesized in a flame cvd process for nanoparticles is performed.
本文应用cfd商业软件fluent,对火焰cvd法合成二氧化钛纳米颗粒的过程进行了数值模拟。
in this paper, we will introduce the synthesis and their properties research of mesoporous titania and zircon.
在本论文中,我们将分两个独立的体系,分别介绍中孔二氧化钛、二氧化锆的合成及其性能研究。
the paper involves the progress of preparation technology of nanometer titania, and focus on the preparation of nanometer titania via liquid phase methods.
论述了国内纳米二氧化钛微粒制备工艺的进展,重点论述了液相法制备纳米二氧化钛的相关技术进展。
the recent progresses of codoped titania photocatalyst are reviewed.
综述了近年来共掺杂二氧化钛光催化剂的研究进展。
using the commercial cfd-code fluent, the simulation of the growth process of titania nanoparticle synthesized in a flame cvd process for nanoparticles is detailedly performed.
本文应用cfd商业软件fluent,对火焰cvd法合成二氧化钛纳米颗粒的过程进行了详细的数值模拟。
with the increasing of sputtering time, the crystallization of the titania film was improved.
该方法所制备的二氧化钛薄膜有较高的均匀性和附着力。
by controlling the hydration of alkoxide, and with n-butanol azeotropic distillation and ethanol rinsing methods, the preparation process of superfine titania powder was investigated in detail.
利用控制醇盐水解的方法,分别采用正丁醇共沸蒸馏和乙醇洗涤这两种工艺,详细研究了超细二氧化钛粉体的制备过程。
titania is itself very cheap: in a larger-grained form, it is the pigment in white paint.
二氧化钛本身很便宜,呈颗粒状,是做成白色油漆的染料。
in this article, titania nano-powders were synthesized by using sol-gel method, to discuss the process of preparation of nanotube by microwave method on this basis.
在本文中,首先利用溶胶-凝胶法制备得到二氧化钛纳米粉体,在此基础上初步探讨微波法制备二氧化钛纳米管的工艺。
it involves the progress of using nanometer titania as material of chemical at last.
最后论述了纳米二氧化钛作化工材料的应用进展。
the devices generated roughly 160 microlitres of the hydrocarbons per hour per gram of their titania nanotubes, a rate at least 20 times higher than in previous studies done with ultraviolet light.
每克二氧化钛纳米管可以使这个装置大约每小时生成160毫升碳氢化学物。这个反应速率至少要快于先前在紫外线下得到的结果20倍。
a typical nanostructured titania super hydrophilic film was chosen for general characterization employing a scanning probe microscope(spm)and an electrochemical measurement system.
选用典型的二氧化钛纳米超亲水薄膜,用扫描探针显微镜(spm )和电化学测试系统进行一般性的表征。
according to the design feature of mica titania and using electric double layer, the composite mechanism of ato and mica titania was discussed.
从云母钛表面结构特点入手,利用双电层概念,探讨了ato与基质云母钛的复合机理。
so appropriate porous titania coatings can be gained by adjusting the micro-arc anodic oxidation time in the composite oxidation method.
可控制微弧氧化时间得到结构较为理想的多孔二氧化钛梯度涂层。
the results show that there are obvious effects on the structure and properties of titania coatings when the voltage changes.
结果表明:电压对多孔二氧化钛涂层的结构和性能有很大影响。
in this paper the general situation of preparation of nano titania was reviewed.
综述了纳米二氧化钛的各种制备方法以及研究进展。
the basic principle of sputtering was presented, and the targets and techniques used in the preparation of titania thin film from sputtering were reviewed and discussed.
介绍了溅射法镀膜的基本原理,阐述了溅射法镀二氧化钛薄膜用靶材及相应溅射镀膜工艺的研究现状。
quick surface metallization of titania powder was carried out by electroless chemical deposition of nickel.
采用镍的无电子化学沉积方法研究了纳米二氧化钛粉末表面的快速金属化。
the liquid synthesis of nanocrystals titania at low temperature, due to avoiding the sintering process, brings superior physical and chemical properties.
低温液相合成晶态纳米二氧化钛由于避免了高温煅烧过程,可望赋予其更优越的特性。
nanonsized anatase titania colloid and powders were prepared by hydrolysis of titanium tetrabutoxide in basic media and then dehydrated at 70℃ in acid media.
采用醇盐的乙醇溶液,在70 ℃下水解与结晶分步进行,制备了纳米锐钛矿相二氧化钛胶体及粉体。
the porous titania coating containing ca and p with preferable microstructure and property can be prepared when the voltage is at 300 v.
在300v电压下可得到结构和性能较为理想多孔二氧化钛梯度涂层。