片语

uniaxial and biaxial tension单双轴拉伸

concrete by uniaxial tension混凝土单轴拉伸

uniaxial tension or compression单轴拉伸

direct uniaxial tension test直接单轴拉伸

uniaxial tension-compression拉

simple tension单向拉伸；简单拉伸；纯拉力

uniaxial tension test单轴抗拉强度

uniaxial tension strength直接单轴抗拉强度

英汉例句

• when the specimen bears uniaxial tension or double-axial tension, the value of the maximum stress near the hole side is different and the position of the maximum stress is also different.

  不同形状孔附近的应力集中程度还与土工织物试样的拉伸条件有关，试样单向拉伸或双向拉伸时，孔边的最大应力值不同，最大应力所出现的位置也不同。

• specimens of pig corneas were systematically tested in uniaxial tension experiment to determine their ultimate strength, breaking energy, effective nonlinear stress-strain relations, and hysteresis.

  对猪眼角膜进行了有系统的单轴拉伸实验，通过实验来确定其极限强度，断裂能、显着非线性的应力-应变关系和滞后环。

• the parameters to controll ductile crack growth were gotten from the simulating uniaxial tension test, which means that tests of the same material can be forecasted each other based the cell model.

  通过单轴拉伸试验的模拟结果，得出反映材料微观损伤的控制参量，再根据该参量对同种材料的标準三点弯曲试验进行定量预测，即实现从一种试验结果预测同种材料的其它试验结果。

• it is not stress-strain relation but the stress-displacement relation ship that can be obtained in an experiment of concrete under uniaxial tension due to its severe local softening behavior.

  混凝土受拉本构行为存在很强的局部软化现象，使得单轴受拉试验无法给出应力-应变关系，而只能给出应力-位移关系。

• the forming, growing, blocking and gathering of dislocation in if steel during uniaxial tension are investigated using tem testing.

  利用透视电镜研究了if钢在单向拉伸各阶段中的位错形成、增生、阻塞和滑移的演变过程。

• abstract :the stress relaxation behavior and springback equation of 7050 aluminum alloys during the age-forming process were studied through self-designed uniaxial tension device.

  通过自主设计的单向拉伸应力松弛装置研究7050铝合金时效成形过程中的应力松弛行为和回弹方程。

• phase transformation from austenite to martensite in niti alloy strips under uniaxial tension has been observed in experiments and has been numerically simulated as a localized deformation.

  单向拉伸镍钛合金带中从奥氏体到马氏体的相变已在实验中观测到，并被看作为局部变形进行了数值模拟。

• to study the size effect on forming process of micro sheet metal, the uniaxial tension experiment was conducted with the aisi stainless sheet metal with the thickness of 0.

  从金属塑性理论出发，结合拼焊板成形特点，推导出同材差厚拼焊板试件单向拉伸情况下缩颈时焊缝两侧薄厚板变形量公式。

• finally, the new system model is validated by a set of uniaxial tension test data of concrete, which had been performed by authors in the laboratory.

  最后，通过在实验室完成的一组混凝土单轴拉伸试验验证了这个系统模型的合理性。

• the flow stress of ferrite/pearlite steel under uniaxial tension was simulated with finite element method (fem) by applying commercial software marc/mentat.

  应用marc/mentat商用有限元软件，对铁素体/珠光体钢的单向拉伸过程进行了有限元模拟。

• back-analysis method and computing program of damage parameters by the curve of stress-strain by uniaxial tension and compression test was made out.

  在研究了反分析算法的同时，编制了基于混凝土单轴拉压的应力应变全曲线的试验数据，反演其损伤参数的计算程序。

• analytical solution of complete stress-strain curve of rock specimen in uniaxial tension is proposed based on gradient-dependent plasticity considering strain localization initiated at peak strength.

  基于梯度塑性理论，考虑了应变局部化，提出单轴拉伸条件下巖样全程应力–应变曲线解析解。

• the method of uniaxial tension test of concrete under ultra-low loading rate is described. it can be used to determine the characteristic curve of concrete under loading condition.

  本文介绍极慢速加荷条件下混凝土轴向拉伸试验方法，它能测定混凝土受载时的特性曲线。

• in this paper, numerical simulation and experimental studies on the cavity growth were carried out in the case of uniaxial tension of superplastic magnesium alloy.

  本文对镁合金超塑性单向拉伸过程中空洞生长进行了数值模拟和实验研究。

• in this research x65 pipeline steel is chosen as the test material, and uniaxial tension test and cod test of x65 are made.

  本研究采用x65管线钢为实验材料，对其进行了单轴拉伸实验和三点弯曲实验；

• uniaxial tensile test is performed to study the uniaxial tension crack characteristics of undisturbed loess.

  通过单轴拉伸试验、研究原状黄土的单轴拉裂特性。

• orientation stability during uniaxial tension of face-centered cubic (fcc) metal sheets is predicted using a rate-sensitive crystal plasticity model.

  采用速率敏感晶体塑性理论，预测了面心立方金属板材单轴拉伸过程中主要理想取向的稳定性。