Unscrew the nut that connects the drain to the flange using an adjustable wrench if you are replacing the pop-up drain. Then remove the drain flange from the T-connector.
如果你想替换弹出式排水管,你可用可调式扳手拆除连接排水管和法兰的螺丝,然后从T型三通处拆掉排水法兰。
Unscrew the Allen screw in the middle of valve cap and lift up the cap just enough to pick up the old diaphragm.
旋松阀帽中间的内六角螺丝,并且提起阀帽,正好足够拿走旧阀膜。
Unscrew the valve cap and set it to the side or in a pocket where you won「t lose it.
拧下阀盖,并设置它的侧面或装在口袋里,你不会失去它。
Unscrew the screw (3) with Allen key, and take out the external skive tool.
用随机附送的内六角扳手松开螺丝(3),拿出外剥刀具。
Unscrew the locking handle found on the side of the phase shift 」Siko'unit; this enables the adjusting handle to be turned.
旋开移相器上「西科」牌(?)装置一端的止动柄,即可转动止动柄而调整移相器。
Unscrew the bonnet by turning counterclockwise.
反时针方向旋转拧松阀盖。
Unscrew the nut from the service connection of suction line valve and connect the compound pressure gauge.
将真空泵连于复合压力表,打开复合压力表和真空泵对室内机和连接管抽真空。
Unscrew the aerator from the faucet, turn the water on at the shutoff valves, and open the faucet.
松开水龙头的透气口,打开总阀送水,打开水龙头。
Using an appropriate sized wrench, loosen the check valve cover. Unscrew the check valve cover and lift it off.
采用尺寸大小适中的扳手松开止回阀阀盖。宁松止回阀阀盖并将其取出来。
Using an appropriate sized wrench, loosen the check valve cover. Unscrew the check valve cover and lift off.
采用大小适中的扳手,松开止回阀盖。旋下止回阀盖螺丝并拿起。
Unscrew the diaphragm from the compressor.
从压缩装置上拧松隔膜。
Unscrew the jar and cover with lid fitted over it.
旋开罐盖,用合适的盖子覆盖。