allowable deviation中文,allowable deviation的意思,allowable deviation翻译及用法

2026-05-05 13:31 浏览次数 19

allowable deviation

[əˈlauəbl ˌdi:vi:ˈeɪʃən]

[仪] 容许偏差;允许误差

allowable deviation 片语

片语

allowable voltage deviation容许电压偏差

allowable e deviation容许偏差

allowable installation deviation允许安装偏差

allowable deviation limit允许偏差

tolerance deviation容许偏差

Dimension and Position Allowable Deviation基础尺寸和位置允许偏差值

maximum allowable deviation最大允许偏差

pre-established allowable deviation预定允许偏差

permissible error[电子] 允许误差

Extruded board allowable deviation允许偏差

allowable deviation 例句

英汉例句

  • the sum of the parts of the mating parts is less than or equal to the allowable deviation of the assembly.

    选定配合副中一个零件制造成多种尺寸作为调整件,装配时利用它来调整到装配允许的偏差;

  • in this method, the machining tolerance of parts can be enlarged several times according to the allowable deviation of assembly precision requirement.

    相互配合零件公差之和小于或等于装配允许偏差,零件完全互换。 对零件不需挑选、调整或修配就能达到装配精度要求。

  • what is the allowable deviation from straightness for a 40 foot long primary truss member ?

    对40英寸长的主珩架构件允许的直线度偏差是多少?

  • in this paper, 6 typical variation conditions are calculated and analyzed. the maximum allowable deviation range of raceway position is determining as a control value for machining and measuring.

    文中对6种典型变化情况进行了计算分析,从中确定滚道位置最大允许偏差范围,作为加工和测量时的控制值。

  • respectively using magnesium oxide and bone ash cupels, the result deviation of gold content in the samples is within the allowable deviation of the national standards.

    分别使用镁砂灰皿和骨灰灰皿,样品含au量的分析结果与理论含au量的偏差均在国家标準的允差范围内;

  • bolt hole spacing should be consistent with the allowable deviation of norms.

    螺栓孔孔距的允许偏差应符合规范的规定。

  • the allowable deviation of the filter poles determine the bound of the coefficients accuracy, therefore the minimum wordlength in the filter mechanization is determined. in this paper, the…

    滤波器极点的允许偏差决定着系数精度的边界,从而决定着实现滤波器的数字机的最小字长并给出了计算滤波器基本单元系数字长的公式。

相关热词