片语

Optimum asphalt content range最佳沥青含量范围

Design asphalt content设计沥青含量

effective asphalt content有效沥青含量

Initial asphalt content初试沥青用量

Asphalt emulsion content乳化沥青用量

asphalt binder content沥青用量

soluble asphalt content可溶沥青含量

asphalt optimum content最佳沥青用量

英汉例句

• The inspecting value of sample for asphalt content sampling of asphalt mix is normal distribution.

  沥青混合料沥青含量抽样检测的样本检测值服从正态分布。

• Then, it makes target mixture proportion design to study on the aggregate scope, optimum asphalt content of mixture, the temperature and time of curing.

  进行了环氧沥青混合料目标配合比设计，确定了矿料的级配范围、混合料的最佳油石比以及高温固化温度、时间等参数。

• Segregation by the laboratory to simulate different levels of asphalt mixture, including the choice of method of gradation, asphalt content of the segregation level with the setting.

  通过实验室内模拟不同离析程度的沥青混合料，包括级配的选择方法，各离析级配沥青含量的确定等。

• Test results indicate that void ratio, asphalt content and density have great influence on road usage performance of recycle asphalt mixture.

  试验结果表明，空隙率、沥青含量和密度对再生沥青混合料路用性能影响很大。

• It is pointed that with rock asphalt content increasing, its effectives wears off. When content increases from 20% to 25%, performance of mixture has little change.

  研究认为，随着巖沥青掺量的增加，其对混合料路用性能的影响逐渐减弱，当掺量由20%增加到25%时，性能变化很小。

• The pavement properties, such as thickness, compaction, void content, moisture content and asphalt content etc, are all obtained based on the study of pavement dielectric property.

  同时，路面材料作为一种复合介质，建立其介电常数模型是研究复合介质介电特性的基础。

• The different asphalt content mixtures are shaped at different compaction temperature, the relationship of compaction temperature to physical-mechanical parameters is researched in the paper.

  对不同沥青含量的沥青混合料在不同击实温度下击实成型，研究击实温度与混合料各物理力学参数之间的相关关系。

• Then, it makes target mixture proportion design to study on the aggregate gradation scope, optimum asphalt content of mixture, the temperature and time of curing.

  然后，对确定配合比例的国产环氧沥青进行混合料目标配合比设计，确定了矿料的级配范围、混合料的最佳油石比以及高温固化温度、时间等参数。

• Based on the experiment results on three kinds of open graded ATPB, it is concluded that asphalt content should be above 2.5% and porosity should be above 18%.

  本文经对三种开级配的沥青稳定碎石进行了试验研究，得出ATPB的沥青用量应在2.5%以上，空隙率在18%以上的结论。

• Stable conductive performance can be achieved by controlled graphite content and asphalt content and increasing the compact degree.

  通过控制沥青用量和石墨用量，增加沥青混凝土的压实度，可获得稳定的导电性能。

• Results and analyses show that the use of the additives will increase the optimum asphalt content by about 0.

  试验结果与分析表明，各种添加剂的掺入将使最佳沥青用量增加约0。

• The items of the quality testing were included the viscosity of recycling asphalt, asphalt content of reclaimed asphalt concrete materials, compaction, surface smoothness and placement temperature.

  再生沥青混凝土质量检验项目包括再生沥青的黏度、刨除料含油量、压实度、路面平坦度与施工温度等。

• The asphalt content is one of the most important control targets in the production of the asphalt concrete.

  沥青含量是沥青混凝土生产中最主要的控制指标之一。

• An asphalt mixture base with a high void volume was designed by volume design procedure, and optimum asphalt content of mixture was determined by Marshall test.

  采用体积法设计高空隙率的基体沥青混合料并通过马歇尔试验确定其最佳沥青用量；