英汉例句

• the simulation results show that, at the same relief discharge, the bigger the permeability is, the bigger the extrusion pressure of casing damage is.

  研究表明：在放喷流量相同的情况下，渗透率越低，储层厚度越薄，压差越大，套管承受的挤压力就越大。

• the influence of the isothermal temperature, the stirring speed and the extrusion pressure on quality of the formed parts were investigated.

  研究了半固态等温温度、搅拌速率和挤压力对成型件质量的影响。

• the effect of billet size on the effective strain and unit extrusion pressure was investigated during equal channel angular pressing.

  研究了坯料尺寸对等径角挤压材料等效应变及单位挤压力的影响。

• the size dimension of the ion imprinting polymer porous small ball can be controlled by controlling the extrusion pressure and oscillation frequency.

  该离子印迹聚合物多孔小球可以通过控挤出压力和振蕩频率来控制尺寸大小。

• combined the extrudate rheology character, the function relationship among the screw extrusion pressure and the screw working parameter, and the screw geometry dimension were established.

  确定了物料实现顺利挤出通过挤压机的机头和机嘴部分所需的压力。

• a three dimensional upper bound analysis technique for calculating the extrusion pressure of a spline shaft was presented in this paper.

  本文给出了花键轴开式整体凹模挤压时挤压力计算的三维上限分析法。

• on the one hand, simulate the wallboard extruding process to find the action mode of extrusion pressure and the distribution of inner stress of flat receptacle by photoelastic experiment.

  一是用光弹性实验法对扁挤压筒挤压成形壁板过程进行模拟，确定了挤压力的作用方式和扁挤压筒内部的应力分布；

• in this paper the extrusion pressure between the stud and the workpiece during stepping arc stud welding process is acted as the controlled variable so as to control the stud plunge depth.

  基于步进式电弧螺柱焊方法，以焊接过程中螺柱与工件之间挤压力为控制量，实现对螺柱送进深度的控制。

• the result showed that proper vibration force field could reduce the extrusion pressure and the extrusion power, and could effectively improve the mixing degree of filled polymer system.

  结果表明，在一定的振动条件下，振动力场的作用使挤出压力减小，挤出功率降低，混合分散效果明显提高。

• by the way of cooling, the distance between the welding position and the joint of the two pipes could be shortened, so the extrusion pressure was reduced, and the extrusion rate was increased.

  由于采用了冷却的方式，焊接部位与两管结合部位的距离可以缩短，减少了挤出压力，提高了挤出速度；

• it is important to prolong the service life of the mould and raise the economical benefits while reduce the extrusion pressure and prolong the period of equipment maintenance.

  而且也能起到减少锌筒成型挤压力，延缓设备修理周期的作用。

• the simulation results show that, with increasing the milling time, the densification of powders becomes more and more difficult, and the needed extrusion pressure substantially rises.

  分析结果表明，随着球磨时间的延长，粉末固结致密难度增加，所需挤压力显着增大。