片语

internal load stress荷载内力

internal frictional stress内摩擦应力

druckeigenspannung internal compressive stress内部压缩应力

internal friction stress内摩擦应力

internal fractional stress内摩擦应力

internal hardening stress淬火内应力

internal l stress内部应力

internal ratio stress relaxation内应力松弛

internal load stress calculation荷载内力计算

英汉例句

• appropriate amount of oxygen is beneficial to improving surface structure of film, reducing the crystal defects and the internal stress of films.

  实验发现，适量的氧气可以减少晶体缺陷，减小膜的内应力，提高薄膜的结晶质量。

• therefore metal magnetic memory testing(mmt) equipments could be used in measuring internal stress of seamless railway.

  提出金属磁记忆法可以对钢轨内应力进行定量测量。

• the computation of static model and dynamic model show that the internal stress of the rubber pad concentrates at the corner of the stress-bearing surface.

  静态模型和动态模型计算结果表明，橡胶垫内部应力集中出现在受力面转角处。

• with the decrease of core sizes, the impact strength modified systems increases and the internal stress of modified systems decreases apparently, while shearing strength changes slightly.

  随着核壳粒子橡胶相尺寸的减小，改性体系的沖击强度逐渐增加，内应力降低，但对体系的剪切强度影响并不显着。

• it was previously suggested that growth in the midribs might provide enough internal stress for the petals to burst out of their casing.

  过去人们认为是花瓣中脉的生长产生了足够的内部张力让花瓣从花蕾中伸展开来。

• through redesigning the crankshaft counterbalance piece and the journal transition fillets, the aim improving the crankshaft internal stress distribution is achieved.

  通过重新设计曲轴平衡重和轴颈过渡圆角，达到改进曲轴内部应力分布的目的。

• however, some problems, such as film crack and falling off from the substrate, appear during the subsequent processing because of the high internal stress of su-8 photoresist.

  然而su-8胶在工艺过程中会产生很大的内应力，导致在后续的工艺过程中出现胶体开裂，甚至从基底上脱落等现象。

• for more than a century researchers have known the basics of how limestone caves form: a tiny fracture opens in the rock perhaps due to some internal stress and water begins percolating through it.

  超过一个世纪以来，研究者就懂得石灰巖洞形成的基本原理：可能由于内部的压力，石头上出现了微小的裂缝，然后水开始渗透。

• to remove internal stress such as those produced by drawing, bending, or welding.

  去除内应力，如用沖压、完全或焊接成型的工件。

• internal stress of su-8 layer was measured after the peb by the theory of curvature method. it proves that lowering the peb temperature can greatly reduce the internal stress.

  在su-8胶后烘后，利用基片曲率法的原理测量了胶层内应力的大小，实验数据表明，采用较低的后烘温度可以降低su-8胶层的内应力。

• in calculation, adopted load-unload criterion of stress wave propagation was to decide load-unload state of element and to adjusts and transfers internal stress for tensile failure element as well.

  计算中用应力波传播的加卸载判别準则来决定单元的加卸载状态，对受拉破坏单元进行内部应力调整和应力转移。

• the internal stress is consisting of circumferential stress and axial stress, from which the compound stress of the weld seam is derived.

  该内应力由环向应力和轴向应力构成，据此推导出了焊缝处的合成应力。

• bearing parts in the process of hardening cooling by internal stress due to the formation of quenching cracks crack said.

  轴承零件在淬火冷却过程中因内应力所形成的裂纹称淬火裂纹。

• sensitivity index of external stress is only affected by sensitivity constant, while index of internal stress is affected by both sensitivity constant and porosity.

  巖石的外应力敏感指数仅受敏感常数的影响，巖石的内应力指数受敏感常数和孔隙度的共同影响。

• lower molecular weight and broader molecular weight distribution in thermoplastics favor lower orientation and reduced internal stress in moldings.

  在热塑性塑料中较小的分子量以及较宽泛的分子量分布促成方向性减少同时降低注塑件中的内应力。

• the combined action of the applied and internal stress has brought about the formation of dislocation patterns in the process of plastic deformation.

  金属塑性变形过程中，外加应力和内应力的共同作用导致位错组态的形成。

• in short, the causes of cracks caused by hardening of these factors may be one or more, the existence of internal stress is the main reason for the formation of quenching cracks.

  总之，造成淬火裂纹的原因可能是上述因素的一种或多种，内应力的存在是形成淬火裂纹的主要原因。

• the results showed that it was viable to use csr measuring creep internal stress of high temperature components and effective to forecast residual life of high temperature components using …

  结果表明，用csr法测定高温构件的蠕变内应力是可行的，将蠕变内应力用于高温构件的剩余寿命预测是有效的，并可克服一般外推方法的不足。

• the relative internal stress of uv-curing coatings with bases is measured by using diffuse right polariscope wem-300 based on the principle of photoelastic.

  根据光弹原理，用漫射式振光弹仪测定了光固化涂层与基材的相对内应力。

• the internal stress in diamond thin films deposited by dc plasma cvd was studied as a function of methane concentration and deposited temperature.

  研究了直流等离子体化学汽相沉积（cvd）法合成的金刚石膜内应力随甲烷浓度、沉积温度的变化关系。

• the finite element was applied to analyze the thermal effect of ld end-pumped a-cut nd∶yvo4 crystal, including temperature distribution, internal stress and its deformation.

  用有限元法分析激光二极管端面抽运a轴切割nd∶yvo4固体激光器的晶体热效应，包括温度分布、内部应力和产生的形变。

• when the nickel sulfate and sodium citrate concentration were increased, the internal stress increased firstly and then reduced.

  而随着钨酸钠浓度的增加，镀层内应力则是单调增加的。