片语

Main Amplifying Circuit主放大电路

main transformer circuit breaker主变压器开关

Main Control Circuit主控电路

main discharge circuit主放电回路

main battery circuit主电池电路

main-circuit loop主回路

main electric circuit电气主结线

main fire circuit消防总管

main amplifier circuit主放大器电路

critical axis主轴；主通道，主回路

英汉例句

• At the present This thesis has the system's scheme of hardware main circuit diagram and software design.

  在本次论文中，给出了控制系统的主电路图及软件设计。

• The conditions of voltage between contactors and current in main circuit under different using types are analyzed in detail, then designed the control sequences with working mode AC1-AC4.

  详细分析了交流接触器在不同使用条件下的闭合与分断时触点两端电压与回路电流情况，并研究了AC1～AC4工作制下的控制时序。

• Two main problems in designing the main circuit of switching mode excitation controller are peek voltage and over current of switching device.

  开关式励磁调节器主回路设计中需要考虑的两个主要问题是开关器件的尖峰电压和沖击电流。

• The feasibility of the project is validated by analysing the experiment results of main circuit wave.

  通过对主电路波形的实验分析验证了该方案的可行性。

• The missile rudder servo controller adopts TMS320F2812 as main CPU, IR2110 as drive chip. Each part of main circuit is analyzed in detail.

  以TMS320F2812作为主控CPU，以IR2110作为驱动芯片，完成了导弹舵机伺服控制系统的硬件设计，进行了控制器主电路的分析与设计。

• We put forword the idea of design warp tension independent system consists of main circuit based on S3C44B0X and peripheral circuit, which can be integrated into the whole loom control system.

  在硬件电路设计方面，提出以S3C44B0X为核心的主电路设计与外围电路设计两部分协同设计经纱张力独立系统，集成到整个织机控制系统中。

• Based on the model, the influence of the main circuit on the temperature rise of ac contactor was researched.

  最后利用建立的热分析模型分析了主回路发热对接触器温升的影响。

• The paper analyzes and designs the main circuit of high-power IGBT inverted air plasma cutting power supply.

  对一种大功率IGBT逆变式空气等离子切割电源的主电路进行了原理分析与设计。

• The main circuit of Power Quality Compensator (PQC) for distribution system is studied in this paper.

  对配电系统电能质量补偿装置的主电路进行了研究。

• This article introduced emphatically the control strategy, position detection and identification, drive technique as well as main circuit of permanent magnet Ac servo system.

  重点介绍了永磁交流伺服系统的控制策略，位置检测和辨识、主电路和驱动技术等关键技术。

• Designs on motor field and structure, controller main circuit current commuting mode design, TMS320F240 least system and system program consider system normal operation under fault condition fully.

  电机场路结构设计、控制器主回路换流模式设计、TMS320F 240最小系统设计、程序设计充分考虑了故障应急状态下系统正常运行必要条件。

• How to choice parameters of PFC main circuit using DSP as control center is described, what is more, two methods to select parameters of PID adjuster are also discussed.

  文中讨论了采用数字信号处理器(dsp)作为控制核心时PF C主电路参数的选择，并详细讨论了两种数字PID调节器参数的确定方法。

• This article analyzes the main circuit and control circuit of the welder, also points out the troubleshooting and solutions.

  对焊机主电路和控制电路进行了解析，给出了常见故障的处置和维修方法。

• This device consists of inverter major circuit and monitoring system based on ARM7 chip AT91M55800. The main circuit produces power supersonic AC output with adjustable frequency and changeable power.

  该装置由逆变主电路和以arm 7单片机at91 M 55800为核心的测控系统组成。逆变主电路实现了频率和功率均可调的超声频交流电的输出。