the results showed that the elevated mixing temperature and the internal mixer were beneficial to improve the dispersibility of nano-zno;
结果表明,提高混炼温度,采用密炼机混炼,对提高分散性有利;
the mixing temperature of the flow is gained from the heat balance equation.
通过建立热平衡方程,求出流体混合温度。
the result shows, the ester exchange reaction did take place in pc/pet melting blend system, the extent of exchange reaction depends on content of the components, mixing temperature and mixing time.
结果表明,pc/pet共混体系在熔融过程中有酯交换反应发生,反应程度与组分含量、熔融温度和共混时间有关。
single-factor and orthogonal tests were carried out for the determination of the optimal mixing temperature and the processing technology for and formula of coagulant milk, respectively.
对沖浆温度进行单因素试验,对制作工艺与配方分别进行了正交试验。
the heat generated in the chlorination reaction in the mixing phase of urea and sodium hypochlorite was removed by -5 ℃ brine to control the final material mixing temperature between 15 and 30 ℃.
采用-5℃冷冻盐水移走尿素、次氯酸钠混合段内氯化反应放出的热量,控制物料混合终点温度在15~30℃;
the factors influencing the stability of emulsion of clove oil such as type and concentration of emulsifier, amount of added arabic gum, and mixing temperature and time were studied.
对影响乳状液稳定性的因素如乳化剂种类、乳化剂浓度、阿拉伯胶浓度、混合温度及混合时间等进行了研究。
the influence of the mixing temperature and blending ratio on the mechanical properties of cr/pvc blend was investigated and the microstructure of cr/pvc blend was observed on tem.
研究了混炼温度和橡塑共混比对cr/pvc共混物力学性能的影响,并通过电镜观察cr/pvc共混物的微观结构。
mixing temperature of warm mix asphalt is lower by 30~40℃than that of hot mix asphalt, while the properties of both mix asphalt are quite similar.
温拌沥青混合料的拌和温度比热拌沥青混合料低30~40℃,但二者路用性能基本相同。
under esterification conditions of mixing temperature of 50 ℃, esterification temperature of 110 ℃, the esterification yield was over 98%.
研究表明,当酯化反应中原料混合温度为50℃左右,酯化温度为110℃,酯化收率超过98%。
the wma's mixing temperature can be from 80℃to 120℃.
这种温拌沥青混合料拌和温度在80-120℃之间。
because the wether suddenly cold heat mixing temperature changes suddenly.
因为这时天气忽冷忽热气温变化很快。
the features of various components in all steel radial truck tire are analysed and the measures for controlling the mixing temperature and obtaining the homogenous mixing are proposed.
分析了全钢载重子午线轮胎各部位的胶料特点,提出了其混炼温度控制及均匀混炼措施。
at the same time, the lower mixing temperature and compacting temperature of wma has significantly promote the project quality and construction in the cold moisture environment of tunnel.
同时,在隧道阴冷潮湿的特殊环境条件下施工,wma较低的拌和压实温度对于保证工程质量意义重大。