片语

position-loop figure PID位置环数字PID算法

position tracking loop位置跟蹤环路

position control loop[电子]

position closed loop control位置闭环控制

digital position stabilization loop数字稳定回路

position n loop位置环

Xe-bank position control loop氙控制组位置调节回路

position closed loop位置闭环

英汉例句

• The current loop, speed loop and position loop of the system were designed with the help of engineering design method of automation system regulator.

  按照自动控制系统调节器的工程设计方法，完成了位置环、速度环、电流环的设计。

• Secondly, the control of position loop was improved by using compound control with velocity and acceleration feed-forward control and digital notch filter control in feeding servo system.

  其次对位置环的控制进行了改进，将位置前馈改进为速度前馈和加速度前馈，并在前向通路中增加了一个数字阶式滤波器组成复合运动控制器。

• According to the motor mathematical model, control system is confirmed to dual loops feedback construction including position loop and current loop.

  根据扫描电机的数学模型确定了位置反馈加电流反馈的双闭环负反馈控制结构。

• The series control with the velocity loop and the position loop is an effective design method in the electro-optical tracking system which requires short respond time and little tracking error.

  在光电实时跟蹤系统中要求响应的时间短、跟蹤误差小，采用速度环和位置环的串级控制是一种有效的设计方法。

• Each position loop has its own IP position controller to meet the required following performance.

  每一位置环采用独立的IP位置控制器以保证系统的跟随特性及进一步提高抗干扰能力。

• The position loop use optical encoder as the feedback element. It is used to search and track the target.

  位置回路采用光电编码器作为反馈元件，完成对目标的搜索、跟蹤。

• Although the general design method of the position loop composed of the position sensor is abnegate, but the information radar servo system has high orientation precision in this way.

  采用该方法，虽然舍弃了由位置传感器构成位置回路的常规设计方法，但情报雷达伺服系统仍然有较高的定位精度。

• Then the drive system of the fin stabilizer is analyzed. To give a control policy which AC motor is controlled by applying electric current loop, speed loop, position loop in this system.

  然后对转鳍驱动系统进行了分析，确定了在系统中使用电流环、速度环、位置环的交流电动机控制策略。

• The result presents that the servo rigidity is more influenced by proportion plus of position loop than by other parameters.

  实验结果表明，直线电动机的伺服刚度只受位置环比例增益的影响较大，而其它的控制参数对伺服刚度幅值影响不大。

• The T-S fuzzy models of the velocity loop and position loop are constructed via the table「s nonlinear dynamic model. Robust-optimal controller of velocity-loop is designed for velocity orientation.

  通过转台的非线性动力学模型建立了转台速度环以及位置环的T - S模糊模型，设计了实现速率定位功能的速度环鲁棒最优控制器。

• The position loop use the PD control algorithm, to increase the system」s phase margin, reduce the system's oscillation and ensure that the control system has good dynamic characteristics.

  位置回路采用PD控制算法，以增加系统相位裕度，减弱系统振蕩，保证控制系统具有良好的动态特性。

• Feedforward control was adopted in position loop and it improved performance.

  系统中位置环采用前馈控制，提高了位置控制性能。

• The parameters of the current loop, velocity loop and position loop were determined.

  确定了电流环、速度环和位置环的参数。

• According to all of these characteristics of the system, a three-loop fuzzy sliding control mode is adopted, the speed and position loop are outer loop, and the current loop is inner loop.

  根据系统这一特点，采用三闭环模糊滑模控制策略，外环为速度和位置闭环，内环为电流闭环的方法设计控制器，并进行了仿真实验研究。

• Based on the continuous casting device in the laboratory of our school, the theory of robust control is applied to position loop system driven by hydraulic servo.

  本课题针对我校实验室结晶器连铸装置，将鲁棒控制理论应用于液压驱动伺服位置环系统的研究开发。