片语

thermal isolation grooves隔热槽

thermal isolation plate隔热板

Cell Thermal isolation温控

diving thermal isolation suit潜水保暖服

thermal isolation materials保温材料

thermal isolation layer绝热层

thermal-isolation structure绝热结构

thermal isolation technique隔热保温技术

thermal insulation[电] 隔热；绝热；[热] 热绝缘

thermal isolation by vegetation植被隔热

英汉例句

• the traditional steady-state joule heating method is improved by inducing a symmetric structure, and a thermal isolation trench is added in suspended si membrane.

  改进了传统稳态加热法的测试结构，设计了带隔离槽的全对称悬空薄膜测试结构，并使用有限元工具对测试结构进行了优化。

• in addition to controlling mechanical shaft and bearing loads, the coupling further protects the encoder by providing a high degree of electrical and thermal isolation between coupled shafts.

  除了控制的机械轴和轴承载荷，耦合进一步保护通过提供电力和热轴之间的耦合隔离高度编码器。

• the influence of the thermal isolation of the ps on resistance's sensitivity of vox film was investigated.

  并在其表面沉积了氧化钒热敏薄膜，研究了多孔硅样品的热绝缘性能对氧化钒热敏薄膜阻温特性的影响。

• the coupled heat transfer in the air cooling channel and thermal isolation layer of an aeroengine is investigated numerically.

  数值研究了某飞机发动机外侧冷气道与隔热层的耦合传热过程。

• this paper describes the classical mathematic model of bolometer, the effect of thermal isolation and noise on detector performance are also discussed.

  总结了非制冷测辐射热计的经典数学模型，并分析了探测器热绝缘结构和噪声对性能的影响，指出了性能改进和优化的基本途径。

• this paper put forward application modes, cautions, and the effect of use of vacuum thermal isolation plate in refrigerator. the prospect of vacuum thermal isolation plate was described.

  指出了真空隔热板在电冰箱隔热保温中的应用方式、注意事项及使用效果，展望了真空隔热板的应用前景。

• instead of surface sacrificial layer and bulk micromachining technique, using polymer as thermal isolation material decreases cost and improves yield.

  以聚合物材料作为绝热材料，避免了表面牺牲层工艺和体加工技术，降低了成本、提高了成品率。

• porous silicon has been used broadly in the fields of micro-sensors because of its special thermal isolation performance and advantages in technology.

  多孔硅由于其热绝缘特性以及技术优势，已经在微传感器领域得到广泛的应用。

• the support straps system of spaceborne radiant coolers requires thermal isolation and it requires to remain high stiffness and strength in order to ensure the radiant coolers structural integrity.

  星载辐射制冷器的级间支撑，即要隔热，又要求保持一定的刚度和强度，保证辐冷器结构的完整性。

• the sensor (10) also includes a cavity formed under the diaphragm layer (16) and is configured to provide thermal isolation of the heating element.

  传感器（10）还包括形成于隔膜层（16）下面 的空腔，并配置成提供加热元件的隔热。

• the principle of thermal isolation structure is discussed . the conversion process of infrared signal to electric signal is given , as well as the equivalent circuit .

  论述了选择热绝缘结构的原则，最后简单介绍了将红外光信号转化为电信号的流程，给出了等效电路。