英语释义

• either of two rods that link the steering gear to the front wheels

片语

steering tie-rod[车辆] 转向横拉桿

tie down rod系留桿

tie-rod hole螺栓孔

gauge tie-rod轨距拉桿

tie e rod拉桿

tie e rod spring拉桿弹簧

tie-rod arm转向臂

英汉例句

• the arrangement of side tie rod is a difficult point in double wishbone independent suspension system design.

  侧拉桿的布置是双横臂独立悬架系统设计过程中的难点。

• available in a range of bore sizes, strokes, and rod diameters, parker tie rod cylinders are rugged and reliable, able to meet medium and heavy duty application requirements.

  可用范围内的一孔大小，笔画，和桿直径，帕克拉桿缸是坚固，可靠，能够满足中型和重型应用需求。

• check the left tie rod joint.

  检查左侧横拉桿接头。

• for corrosive environments, where dirt and abrasives may be ingested, and cause seals to wear faster than normally expected, the afo offers the benefit of tie rod construction.

  因为，腐蚀性环境中，灰尘和磨料可能摄入，并导致密封穿比通常预期的速度更快，踝足矫形器提供了拉桿工程受益。

• however, insure that the tie rod can attach and move without clearance issues prior to any rework.

  然而，确保该拉桿可以附加和问题提出之前没有任何返工清理。

• ltd. ) is a professional manufacturer of suspension control arms for the cars, and ball joint, tie rod and rubber. our new factory was built up in jingdezhen of jiangxi province.

  在江西景德镇市兴建一个工厂，我们的宗旨是集中资金，技术，人才，开发全球汽车零部件新产品，新技术。

• modem gas turbine rotors are usually formed as rod fastening rotor, in which disks are tied together by one central tie rod or several tie rods distributed in the circumference.

  现代燃气轮机转子以拉桿转子的结构为主，拉桿形式为中心单根或周向多根拉桿。

• please note that these switches are compatible with all numatics magnets with the exception of older style hall effect magnets for tie rod cylinders (magnet code 3 option).

  请注意，这些开关是与年纪较大的风格馆拉桿气缸（磁代码3选择）起磁铁外，所有纽曼帝克磁铁兼容。

• by using three dimentional photoelastic frozen stress method, the stresses in a bridge of continuous beam type and with net structured tie rod archs are analyzed.

  采用光弹性冻结应力法对网状系桿拱连续梁桥进行了不同工况下的应力分析，给出了边界应力分布和主应力迹线，为优化工程设计提供了参考依据。

• in the reinforced concrete structure of the project, it could be the slab formwork system matching with plywood, push-pull prop, tie rod and other accessories.

  在现浇钢筋混凝土结构模板工程中，它与多层板、竖向支撑配套使用可形成水平支撑模板体系；与多层板、斜撑及对拉螺栓等配套使用可形成竖向模板体系。

• full steering tie rod is visible as it connects the handlebar in the rear to the steer tube in the front;

  全面转向拉桿是可见的，因为它连车把在后方的引导管在前面；

• fracture analysis of intermediate tie rod was carried out by metallography, scanning electron microscope and eds.

  采用金相显微镜、扫描电镜、电子能谱仪等方法对鉆井泵中间拉桿破断失效进行了分析。

• specially manufacture automotive chassis fittings, steering parts, ball joint, tie rod end, side rod assy, rock and stabilizer link, control arm, idler arm, pitman arm, center link cross rod.

  专业制造汽车底盘部件和转角及转动部件，产品有：悬挂球头、拉桿球头、控制臂球头、转角拉桿球头、拉桿总成、主邦汰、副邦汰等系列。

• cut-off point of tie rod influences toe angle greatly impacted wheels toe angle.

  转向拉桿断开点的位置对车轮前束角的影响很大；

• loosen tie rod at the wheel carrier.

  松开车轮支架处的横拉桿。

• it has also been proved that the tie rod force (f) of anchored sheet pile wall would strongly influence soil settlement.

  并求证了拉锚式支护结构的锚固力f对控制支护土体变形的有利影响。

• tie rod threads are rolled for strength and engagement.

  拉桿线程推出的力量和参与。

• the tie rod at each end of the rack connects to the steering arm on the spindle.

  齿条一端连着拉桿，拉桿与车轮轴上的转向摇臂相连接。

• the main shoe-fixing apparatus consists of main mounting base, main shaft, locking tie rod or pulling rope and display.

  主上鞋器由主安装座、主轴、锁闭拉桿或拉绳和显示器组成。

• the results showed that the intermediate tie rod was fractured by corrosion fatigue.

  结果表明，该中间拉桿的破断属腐蚀疲劳失效。

• the locking tie rod or pulling rope is connected with locking pin.

  锁闭拉桿或拉绳与锁闭销连接。