片语

Welded Plate joint钢板节点

welded butt joint对焊

welded spherical joint焊接球节点

butt welded splice joint对焊拼接

welded pipe joint焊接式管接头

cast welded rail joint铸焊钢轨接头

welded corner joint角焊接

welding line焊缝；缝合线

welding seam[机] 焊缝；对接焊缝

welded d joint焊接缝

welded tubular joint管节点焊缝

英汉例句

• by comparing backgouging of plasma arc with carbon arc to the welded joint of 13-5 martensitic stainless steel, the backgouging of plasma arc is proved feasible for the full penetration weld.

  通过对13-5型马氏体不锈钢焊接接头进行等离子弧清根及碳弧气刨清根的比较，证明等离子弧清根对全焊透焊缝实施背面清根是可行的。

• the influence of re on the microstructure and hardness of welded joint was studied by the experiments adding re in electrode covering.

  通过在药皮中添加稀土合金的试验，研究了稀土对高钒焊条焊补铸铁接头组织与硬度的影响。

• optimization design method of welded structure was put forward with welded joint fatigue damage as constraints.

  提出考虑焊接接头疲劳损伤约束的焊接结构抗疲劳优化设计方法。

• the paper studies the fatigue failure probabilistic model of the weld zone in welded joint using probabilistic fracture mechanics and reliabilitistic analysis methods.

  本文采用概率断裂力学方法和可靠性分析方法，针对压力容器焊接接头的组织不均匀特点，研究了焊缝区疲劳失效概率模型。

• the microstructure and mechanical properties of welded joint of ultra-fine grained rebar were studied.

  研究了超细晶粒钢筋焊接接头的组织和力学性能。

• in addition, the j-integral values are different from the welded joint which contain the crack in the middle of weld seam in two conditions of both plane strain and plane stress.

  结果表明，无论是平面应变还是平面应力条件下，焊接接头j积分值都与全母材和全焊缝材料不同；

• the project solves the technique difficulties of biomaterial connection, tube-shell mechanical strength, ultrafine kovar glass and leaking of welded joint and the problem of industrialization.

  本项目克服了异材连接、管壳机械强度和可伐玻璃细与管壳焊接处漏气的工艺难点，解决了产业化技术问题。

• welded joint category, joint type no. , joint efficiencies.

  焊接接头分类，焊接接头（焊缝）类型，焊接接头系数。

• in welding test of tcs stainless steel, it was found that impact absorbing energy of heat-affected zone(haz)near bond line in welded joint was low.

  在tcs不锈钢前期焊接试验中发现其焊接接头热影响区的沖击吸收功值在熔合线附近较低，原因是接头热影响区晶粒粗大所致。

• results shows that penning in the weakest region of welded joint may strengthen welded toe obviously, and substantially improve ductility and strengthen of weldment.

  结果表明：锤击处理可明显强化焊接接头，特别是随焊锤击能够明显强化焊趾，提高焊件的强度和塑性。

• the welded joint of a thermal exchanger of medium oil cracked which induced the leakage and consequent firing and explosion.

  热媒油交换器箱体在焊缝连接处发生开裂，造成漏油，引发了火灾和爆炸。

• the results indicate that the method can accurately simulate temperature field of welded joint of heat-resistant steel.

  结果表明，所建立的模型可以较準确的模拟耐热钢焊接温度场。

• in the welding craft, the welded joint position affects one of welding quality factors.

  在焊接工艺中，焊缝位置是影响焊接质量的因素之一。

• the weld zone is the weakest in welded joint due to effects of chemical components of filler and crystallization process.

  因焊丝合金化学成分和结晶过程的影响，焊缝处是合金接头的薄弱环节。

• the current status of study on cooling structure of welded joint has been reviewed.

  综合评述了焊接接头冷却组织计算机模拟的现状。

• high quality stainless pipe valve and seamless welded joint can ensure absolutely air conurbation and durability of pipe system.

  高品质不锈钢的管道阀门，无缝焊接的连接口，以保证绝对的气体密闭性和管道系统的耐用性。

• this provides a certain theory and criterion for us to further research the fracture-resistant capability of welded joint .

  这为进一步研究焊接接头的抗断性能分析提供了一定的理论基础。

• the main results indicate that the strength mis matching and geometry of the welded joint specimens have evident effect on the evolution of the plastic zones.

  分析结果显示，不同强度组配和几何特征的焊接接头试样对裂纹尖端塑性区的发展规律有较大的影响。

• in order to ensure the use safety of pressure container, we must test the welded joint angularity and stagger joint.

  为了保证压力容器的使用安全，必须检测焊接棱角度和错边量。

• the properties of the welded joint may be effectively enhanced by adopting neat multi-layer welding and technical welds.

  多层焊和附加工艺焊缝是提高焊接接头性能的有效途径。

• the furnace pipe number, welded joint number and weld worker numbers…

  施焊位置应标注炉管号、焊缝号、焊工号。

• in this paper, the creep compliance of hot-plate welded joint of pe80 pipe is measured, and the effect of creep on the crack tip stress field in the weld is investigated.

  本文测定了燃气用pe80管材热板焊接接头的蠕变柔量，研究了蠕变对焊缝裂尖应力场的影响。

• mechanical properties of pure titanium laser welded joint were tested by universal testing machine.

  采用电子万能试验机测试钛金属激光焊接头的力学性能。