The results showed that the damage in nodular cast iron happens when the applied stress is more than a certain extent, and the damage value increases with stress.
研究结果表明,当应力大于一定程度时损伤发生,且随应力增加而逐渐增大。
It has been found that applied stress has significant influence on pearlite transformation.
发现外加应力对珠光体转变有显着影响。
As the applied stress increases, the incubation time of pearlite phase transformation decreases, but the velocity of phase transformation increases.
当外载增加时,相变孕育期减小,相变速度增加。
This result supports previous fracture models that are based on absolute reaction rate theory and predicts an exponential dependence of crack extension rate on applied stress intensity.
此结果支持了基于绝对反应速率理论的光纤断裂模型,并预测了裂纹扩张速率与外部应力强度的关系。
Both of these statements are based on the tacit assumption that the applied stress does not change during the crack growth process.
这些结论都建立在理想的假设上,即实用应用力在裂纹扩展过程中不变。
Domain switching and propagation of an unloaded indentation crack for BaTiO_3 single crystal under residual stress and applied stress in humid air and water have been in situ investigated.
原位研究了残余应力和外加应力导致BaTiO_3单晶压痕裂纹在湿空气和水中的滞后扩展及畴变。
The fatigue crack extended under the applied stress and led to clutch fork crack and failure.
在工作应力作用下,裂纹不断扩展,最后导致拨叉完全开裂失效。
When applied stress is higher than the threshold stress, the level of hydride reorientation increases with the increase of stress and the number of temperature cycling.
当应力大于应力阈值时,氢化物应力再取向程度随着与应力、温度循环次数增加而增大。
The influence of applied stress on the transformation kinetics and transformation plasticity during pearlite transformation of 45 steel has been studied.
研究了应力对45钢珠光体相变动力学及相变塑性的影响。
The effect of the applied stress magnitude on the average size of O phase is up to 106% and the size standard deviation of O phase increases considerably with applied stress increasing.
The threshold value of the crack opening stress intensity factor is formulated as a function of the hardness, the applied stress and the crack extension.
小裂纹的张开应力强度因子门槛值可近似用一个包括材料硬度、应力水平及裂纹扩展量等参数的函数表示。
The luminous intensity of stress luminescence is in direct ratio with the applied stress in the elastic limit.