the bulk crushing strength and abrasion strength are evidently different with the category of activated carbon.

测定了原粒度活性炭的堆积压碎强度和磨耗强度。

the porosity, bulk density and cold crushing strength of the refractory samples were determined.

讨论了气孔率、体积密度和常温耐压强度与电熔氧化镁加入量之间的关系。

in addition, according to the crushing strength and physical, chemical properties of manganese nodule, the testing method for crushing using toothed roll crusher is established.

同时根据锰结核的破碎强度和物理化学特性确定了用齿辊破碎方式进行破碎的实验方法。

the high temperature crushing strength of carbon composite iron ore hot briquette (ccb)is studied by means of self-made high temperature crushing strength test system under the atmosphere of n_2.

采用自制的高温抗压强度测定装置，研究了热压含碳球团在氮气气氛下的高温抗压强度。

the grey relational degree between pore size distribution and modulus of rupture (mor) of the castable was larger than that with cool crushing strength (ccs) at the same temperature.

在相同热处理温度下，孔径分布与浇注料抗折强度的关联度大于与耐压强度的关联度；

for extrudates there are side crushing strength tests, bulk crushing strength tests, abrasion tests .

对挤条产品有侧压强度的测试，堆积强度测试和耐磨测试。

a mechanics of contact and radial crushing strength are used to analyze the force properties of the photonic crystal fiber which is placed in the v-groove.

运用接触力学和圆环压溃强度理论对由v型槽固定的光子晶体光纤进行了受力分析。

development tendency of mechanical properties is :density increase oil content ratio decreases , brinall hardness increases, crushing strength goes down first and then goes up .

机械性能的变化趋势是：密度增加，含油率下降，布氏硬度增加，而压溃强度先降低后增加。

experiments showed that the former had a higher crushing strength than that of the latter under the same preheating and roasting parameters.

试验表明，在同样的预热、焙烧的工艺参数下，用润磨原料生产的球团矿，其抗压强度高于未润磨原料生产的球团矿；

the turbulence kinetic energy and crushing strength is increased with the increasing of squish area.

适当增大挤气面积，可增大逆挤流强度，提高缸内湍流动能，促进火焰传播。

influence preparation of parameters on crushing strength of the support for residue oil hydrodemetalation catalysts was investigated through experiments.

本文通过实验，探讨了制备条件对渣油加氢脱金属催化剂载体机械强度的影响。