expansion coefficient中文,expansion coefficient的意思,expansion coefficient翻译及用法

2025-11-23 21:07 浏览次数 12

expansion coefficient

英[iksˈpænʃən ˌkəʊəˈfɪʃənt]美[ɪkˈspænʃən ˌkoəˈfɪʃənt]

[物] 膨胀系数,膨胀率;[数] 展开系数

expansion coefficient 片语

片语

multinomial expansion coefficient method多项式展开系数法

expansion factor[高分子] 溶胀因子;[物] 膨胀系数;膨胀率

volumetric thermal expansion coefficient膨胀系数

isobaric expansion coefficient等压膨胀系数

expansion-coefficient of thermal expansion微观热膨胀系数

expansion rate膨胀率;[统计] 扩充率

volume expansion coefficient体积膨胀系数

Equivalent Thermal Expansion Coefficient当量热膨胀系数

cubic expansion coefficient体膨胀系数

expansion n coefficient膨胀系数

thermal expansion reactivity coefficient热膨胀反应性系数

expansion coefficient 例句

英汉例句

  • in this paper, the test method of the linear thermal expansion coefficient of.

    材料膨胀系数的选用对精密机械热误差修正的结果好坏有着决定性的影响。

  • the measurement of micro deformation is the key in youn modulus and linear expansion coefficient experiments.

    在杨氏模量、金属线胀系数实验中,微小形变量的测量是关键环节。

  • influence on expansion coefficient has been analysed.

    对影响膨胀系数的因素进行了分析。

  • during the study we tried to lower the thermal expansion coefficient of cordierite by adding additives.

    在本研究中,还试图通过添加外加剂来降低堇青石的热膨胀系数。

  • the linear expansion coefficient of az91d alloys is non-linear, the fluctuation amplitude of linear expansion coefficient is the minimum before 225℃.

    az91d镁合金的线膨胀系数并非线性变化,在225℃前热挤压az91d镁合金型材的线膨胀系数波动幅度最低。

  • can be installed in cryogenic liquid is lower than the environment temperature linear expansion coefficient test test.

    可装低温液体进行低于环境温度的线膨胀系数测试试验。

  • thermal deformation temperature and liner expansion coefficient of the composite were decreased.

    该复合材料的热变形温度有所降低,但线膨胀系数减小。

  • because the expansion coefficient of concrete is two times as much as that of brick masonry, the temperature cracks occurre easily in the top wall in brick masonry structure.

    由于砼与砖砌体的线膨胀系数相差一倍,在温度作用下,现浇砼屋面的砖混房屋顶层墻体很容易产生裂缝。

  • using orthogonal test, the effect of alloying elements on expansion coefficient of gray iron was investigated; a optimum composition of a kind of high expansion coefficient cast iron wasobtained.

    文中利用正交试验的方法,研究了合金元素对灰铸铁膨胀系数的影响,选择了获得高膨胀系数铸铁的最佳成分。

  • two methods are established to predict the thermal expansion coefficient of unidirectional composite based on micro-mechanics.

    基于细观力学方法建立了两种预测单向复合材料的热膨胀系数的方法。

  • as the project is very brittle ceramic expansion coefficient and small, bearing gap may not be too small to hold axis in order to avoid accidents.

    由于工程陶瓷很脆且膨胀系数小,所以轴承间隙不得过小,以免发生抱轴事故。

  • the expansion coefficient of this new iron without ni element can be closed to that of zl102 al alloy.

    并利用该成分获得了接近zl102合金膨胀系数的新型无镍的高膨胀系数铸铁。

  • the relationship between expansion coefficient and temperature will coincidence with linear relation.

    膨胀系数与温度之间具有良好的线性关系。

  • the corresponding mathematic model has been established in accordance with the physical definition of the density and the expansion coefficient through formula derivation.

    根据密度和膨胀系数的物理定义,通过公式推导,建立了相应的数学模型。

  • volumetric expansion coefficient and compressibility of water and steam are important parameters usually applied in the reactor thermal hydraulic, heat transfer and engineering thermodynamics.

    水和蒸汽的体膨胀系数和压缩率是反应堆热工水力、传热学和工程热力学中常用的参数之一。

  • research shows that with the increased co2 injection, dissolved gas oil ratio, volume expansion coefficient and coefficient increases, viscosity decreases, bound water volume expansion.

    研究表明:随着co2注入量增加,溶解油气比、体积系数和膨胀系数增大,粘度降低,束缚水体积膨胀。

  • the theory and feasibility is analyzed, for measuring linear expansion coefficient of high temperature material by moiré interferometry.

    分析了激光云纹干涉法测量高温材料热膨胀系数的原理和可行性。

  • in addition, statistical and deterministic mathematical models are used for back analysis of equivalent temperature linear expansion coefficient based on the prototype monitoring data.

    此外,基于原型观测资料,利用统计模型和确定性模型对碾压混凝土的等效温度线膨胀系数进行了反演分析。

  • density, porosity, thermal expansion coefficient and intensity were tested by archimedes-method, show the distance and bend resist of three point etc.

    用示差法、阿基米德法、三点弯曲法等方法测试出材料的热膨胀系数、密度、吸水率、气孔率、强度等。

相关热词