英语释义

• the blade of a rotor (as in the compressor of a jet engine)

片语

fan impeller风扇叶轮，[机] 扇风机叶轮

Impeller diamete叶轮直径

impeller agitator桨叶式搅拌机

impeller passage泵轮通道，叶轮流道

anchor impeller锚式搅拌器

impeller diameter叶轮直径

impeller pump叶轮泵

main impeller主推叶轮

impeller blade叶轮片

shrouded impeller[机]

enclosed impeller封闭式叶轮

blower impeller风扇叶轮；压气机叶轮

pump impeller泵轮；泵推动器

unshrouded impeller开式叶轮

英汉例句

• the volute suction shall contain a replaceable 400 series stainless steel wear ring to match the impeller wear ring.

  蜗形吸入室应该包含一个能够与叶轮抗磨环匹配的可替换400系列不锈钢抗磨环。

• cad method for improving design quality and efficiency of centrifugal pump impeller is provided.

  本文为提高离心泵叶轮的设计质量及效率提供了一个新的方法。

• this pump impeller blades can be adjusted automatically to adapt to speed, fluid viscosity and pressure.

  这种泵的叶轮叶片可以自动调节来适应转速、流体粘度和不同压力。

• the intermediate demister shapes air flow swirl generated by impeller rotation to get bigger particle and improve the arresting efficiency of the next filter screen.

  中间除雾装置将叶轮旋转而成的气流旋涡整形，使得粒子进一步变大，从而提高下一个滤网的捕集效率。

• impeller or both water inlet and outlet pipelines blocked up.

  叶轮或进出水管路阻塞.

• water at high-speed rotating impeller and the suction pipes under the gas mixture to form a gas-water mixture to the separation chamber row.

  水在叶轮高速转动的作用下与吸入管来的空气相混合，形成气水混合物排至分离室。

• with the floating impeller structure design, bring down the motor start and running load.

  浮动叶轮结构设计，降低了电机启动及运行负载。

• simulation and experimental results showed that the impeller parts rough machining efficiency was improved by this method.

  结果证明，该方法在一定程度上提高了叶轮零件的粗加工效率。

• shell pumps not only by pooling the impeller shuaichu liquid, is also an energy conversion device.

  泵壳不仅汇集由叶轮甩出的液体，同时又是一个能量转换装置。

• the flow of air through the fan is substantially parallel to the impeller axis.

  通过风机的气流基本上是与叶轮轴平行的.

• with the development of modern science and technology, free-form surfaces are widely used in aviation and space flight, automobile and impeller machines.

  随着现代工业的不断发展，各种自由曲面被广泛应用于航空航天、汽车、叶轮机械等行业。

• and then removed the pump shaft shell removed send impeller repair shop repair.

  然后将轴拆出泵壳，拆下叶轮送修理厂修理。

• in the 1980「s, the 6100 series of heavy duty recessed impeller pumps was developed to serve aggressive in-plant applications such as sludge and grit.

  1980年代，莫里斯公司开发了6100系列重型凹式叶轮泵，特别适用于具有很强破坏性流体介质如软泥和粗砂的泵吸处理。

• the condition for obtaining the minimal number of impeller revolutions is determined.

  确定了获取最小叶片转数的条件.

• it is suggested to use the refitted speedometer with mechanical impeller as the sensor.

  提出用改装后的机械式叶轮风速表作为传感器。

• indoor air at the separation was separated out by the export control scheduling, and the water still flows through the impeller around the outer edge of backwater hole, and mixed air inhalation tube.

  在分离室内空气被分离出来，由出口管排掉，而水仍经左右回水孔流向叶轮外缘，并与吸入管空气相混合。

• impeller are open, and closed three - banbi, as shown in figure 2 - 2 .

  叶轮有开式 、 半闭式和闭式三种, 如图 2-2 所示.

• impeller on the inside and outside smooth surface of requirements to reduce the flow friction loss.

  叶轮上的内外表面要求光滑，以减少水流的摩擦损失。

• spindle quenched renew prime location bearing position, sealing position and the spindle head and impeller position.

  主轴调质措置的首要位置是轴承位、密封位及轴头和叶轮位。

• impeller suitable for the suction of greases with a low penetration index.

  泵叶适合于吸入低渗透性油脂.

• impeller has single - and double - suction suction aspiration of the two methods.

  叶轮有单吸和双吸两种吸液方式.

• however, the type of impeller poor non-blocking, easy to wound, not in pumping with large particles (long fiber), such as treated effluent at the end of media.

  但该型式叶轮的无堵性差，易于缠绕，不宜于抽送含大颗粒（长纤维）等末经处理的污水介质。

• the impeller of the sea water pump is unevenly worn out.

  海水泵叶轮严重单边磨损.

• the results show that the kinetic energy in the impeller region is higher than in the bulk flow.

  结果表明：湍动能分布不均匀，在叶轮区较高，而在主体区较小；

• rotating impeller week, will go to a certain point of view, the local emergence of sandy bay」s largest radial clearance or minimum clearance space.

  叶轮转动一周，会在转到某一角度时，局部出现口环径向间隙的最大间隙或最小间隙。

• the elimination of measures: the right to the manufacturers advisory impeller diameter.

  消除措施: 向厂家咨询正确的叶轮直径.

• in the third chapter, the optimized models, the optimizing and the evaluating system of impeller are studied.

  第三章研究了叶轮的优化模型，对叶轮的优化和评价体系进行了研究。

• yjd star unloader valve and welded steel impeller can also be cast.

  yjd星型卸料器阀体和叶轮可用钢板焊制,也可铸造.

• the objective of this paper is to build a software for axial fans' impeller designing.

  主要工作是开发一种能用于工程实际的轴流风机叶轮设计软件。