片语

inlet valve velocity profiles进气门出口流速分布

inlet air velocity来流速度

maximum inlet velocity最大输入速率

inlet velocity differences滑移条件

inlet velocity head入口速度压头

inlet velocity diagram进口速度图

water inlet velocity进水流速

inlet gas velocity入口气速

absolute inlet velocity绝对流入速度

英汉例句

• the influences of applied magnetic field. inlet velocity profile, initial surface disturbance and surface tension on interface shape were analyzed.

  通过对方程的数值求解，研究了外加磁场强度、进口速度分布、初始表面扰动对界面形状和界面张力的影响。

• the new model can also be used to predict the effects of inlet velocity profile and meter geometry on the meter「s performance, and thereby improves the design of turbine flowmeters.

  利用本文的研究结果还可预测仪表几何参数与来流速度分布对涡轮流量计性能的影响，作为改进仪表设计的理论依据。

• in the type of boundary condition list, select the inlet velocity item, and then click the settings tab .

  在「边界条件的类型」列表中，选择「入口速度」项目，并且然后，单击「设置」标签。

• the shape of the suction chamber decides the inlet velocity distribution of the compression grade in the multiphase pump, and affects the performance of the multiphase pump to a degree.

  吸入室的形状决定了混输泵的压缩级进口的速度分布，对混输泵的性能有一定的影响。

• through transformation to a current centrifugal fan, optimal design is carried out taking the impeller inlet velocity distribution uniformity at the inlet as the optimized target;

  通过对现有的一台离心通风机的改造——对进风口以叶轮进口速度分布均匀性为优化目标进行优化设计；

• the results show that the degree of wall superheat increases as the inlet velocity decreases and the heat flux increases.

  结果表明，壁面过热度随流速的增大而减小，随热流密度的增加而增大；

• the new model can alto be used to predict the effects of inlet velocity profile and meter geometry on the meter」s performance, and thereby improve the design of the turbine flowmeter.

  利用本文的研究结果还可预测仪表几何参数和来流速度分布等因素对涡轮流量计性能的影响，作为改进仪表设计的理论依据。

• however, the length of recirculation zone and turbulence level increase when inlet velocity is increased, tending to increase the bed temperature and the combustion efficiency.

  入口紊流强度之增加时，可使炉床面之温度增加，此意谓着混合效应可促进燃烧反应及效率。

• the boiling heat transfer coefficient increases as the inlet velocity increases and the heat flux decreases.

  而沸腾换热系数随流速的增加而增大，随热流密度的增加而减小；

• the effects of inlet temperature and inlet velocity were taken into account.

  实验考虑了进气速度、进气温度对贫油熄火油气比的影响。

• the results show that: the pressure loss of muffler elements increased dramatically with the inlet velocity increased.

  研究结果表明：消声单元的压力损失随入口流速的提高显着增大。

• and inlet velocity of mixture plays a significant role in catalytic reaction.

  而且燃料混合物的入口流速对表面催化反应有很重要的影响。

• the effect of inlet velocity of fluid on temperature distribution was analyzed.

  分析了副槽入口风速等参数对转子温度分布的影响。

• through calculation and analysis known: coil「s import and export temperature difference with the increase of the inlet velocity of container rising steadily;

  通过计算分析可知：盘管的进出口温差随着容器的入口速度的增大平稳上升；

• in addition, the convergent section angle and the inlet velocity of driving jet also affected the static pressure distribution in the convergent gas-solid injector.

  此外，收缩段的收缩角和驱动气体入口风速对收缩型气固喷射器内的静压分布也均有一定的影响。

• the results showed that: the inlet velocity has the very tremendous influence to the mixing, but the diffusion coefficient」s impact is small to the mixing.

  对内肋型微混合器进行数值模拟得出，入口速度对混合影响较大，而扩散系数对混合的影响较小。

• thus, the nozzle structure has less influence than the inlet velocity on the overall gasifier gas flow field.

  这说明喷嘴的结构对气化炉宏观气相流场的影响并不如入口速度对气相流场的影响显着。

• result of analyzing experiment picturesindicates that particle radial inlet velocity component influences significantly the blade erosionmanner.

  经对实验照片的分析可知，叶轮入口颗粒径向速度的大小是造成叶轮沖击磨损的主要原因。

• result asymmetric inlet velocity profile deflexion could increase the area of low shear stress and the gradient of shear stress.

  结论不对称入口速度剖面可能是诱发动脉粥样硬化发生的一个危险因子。