片语

radial displacement method横向位移法

dam radial displacement坝体变位

radial chromatic displacement径向色位移

radial displacement measurement径向位移测量

radial displacement amplitude magnification径向位移振幅放大系数

pure radial displacement纯径向位移

radial micro-displacement径向微位移

rotor radial displacement转子径向位移

英汉例句

• for poor quality rock masses, the confinement effect on supporting structure for radial displacement of tunnel wall around circular opening is worse when the supporting force is the same.

  在支护力相同时，支护结构对处于较差围巖中的圆形洞室洞壁位移约束效果较差；

• in age matched subjects, the degree of radial displacement for knees with oa signs was greater than those without oa signs. differences were highly significant (p0.001).

  结果：有径向移位的病人年龄大，与无径向移位者对比差异显着（p0.001）；

• in addition, radial displacement attenuates with the increase of viscous damping coefficient.

  粘滞阻尼系数越大径向位移幅值衰减越快。

• after some analysis and calculation of geometric relationship between cage, ball and raceway, a formula for calculating the radial displacement of ribbon cage in bearing was set up.

  通过对保持架、钢球和套圈沟道之间几何关系的分析计算，建立了浪形保持架在轴承内的径向位移量的计算公式；

• the radial displacement of the steel tube keeps direct ratio with the load.

  钢管的径向位移与荷载成正比；

• on the basis of distribution of stresses, it can determine that dam radial displacement is a main factor of axial tensile stress and is less important factor of loop tensile stress.

  根据应力的大小分布可以确定，坝体变形是背管产生较大轴向拉应力的主要因素，是产生环向拉应力的次要因素；

• set up the mathematic model of cover curve to avoid the radial displacement error which evocabled by the thickness of vane.

  通过建立数学模型以消除叶片厚度引起的径向位移误差。

• practice proves that the radial displacement which is based on the relationship between distortion value and time of the surrounding rock, combining with rule of accumulative distortion value cha…

  实践证明，根据围巖内变形量与时间的变化关系并结合累积变形量随径向位移的变化规律及测点径向埋设位置，是确定围巖松动圈范围的有效方法。

• conclusions: it is concluded that radial displacement of meniscus has close connections with age, gender and radiographic signs of osteoarthritis.

  结论：半月板径向移位与年龄、性别、骨性关节炎影像学表现等有明显相关性。

• the measuring of both axial displacement and radial displacement of the rotor forms the base of controlling the whole amb system.

  因此，对转子轴向位移和径向位移的检测就成为控制整个电磁轴承系统的基础。

• objective to investigate the presence of radial displacement of the meniscus in knee joint, and discuses its clinical significance.

  目的观察膝关节半月板周缘性脱位现象并探讨其临床意义。

• conclusion:it concluded that radial displacement of meniscus had close connection with age and radiographic signs of osteoarthritis.

  结论：半月板径向移位与年龄、骨性关节炎影像学表现等有明显相关性。

• with the decrease of thickness of drum wall, the maximum of stress and radial displacement created by materiel pressure increase.

  物料离心液压引起的最大应力和最大径向位移都随着转鼓壁厚的减小而增大。

• after a series of experimental measurements and study, concluded: eddy current sensors on the rotor axial and radial displacement for integration measurements feasible.

  经过一系列的实验测量与研究后，得出结论：用电涡流传感器对电机转子轴向与径向位移进行一体化测量时可行的。

• the stress and radial displacement will increase with the increment of half cone angle and lead.

  正常工况下，螺旋输送器的最大应力强度和最大径向位移都随着半锥角和导程的增加而增大。

• it is found that the maximum radial displacement take places at the arch and the sidewall.

  结果表明：周边最大径向位移发生于拱顶，其次为腰部；

• this new type of bearing is composed of noncontact sensors to detect the radial displacement of its axis, control valve to drive the axis and a controller to regulate the whole system.

  这种新型轴承由检测轴颈位移的非接触式传感器，驱动轴颈的控制阀及调节整个系统的控制器组成。

• in the case of fluid load the radial displacement in transient response mode tends to zero, and the porewater pressure varies relatively smoothly.

  球壳内作用有流体压力时在瞬时响应模式下位移趋近于零，而孔隙水压力变化相对平缓。

• at the same time, the influence laws of the rotational speed and suspended stretch of the tools on the radial displacement and the maximum equivalent stress have been investigated in detail.

  系统地分析了刀具转速和悬伸长度对立铣刀径向位移、最大等效应力的影响规律。

• by calculating the radial displacement of the mobile column and the cylinder, the seal-compensation and seal-swelling principle of the hydraulic prop were analyzed.

  介绍了柱塞悬浮式液压支柱的技术原理和结构特点；通过对支柱活柱筒体和油缸筒体径向位移量的计算，分析了液压支柱密封补偿和密封胀紧原理。

• the max stress of drum is located at the inner surface of column cylinder near the drum bottom. the maximum of stress and radial displacement of drum is proportioned to the square of rotational speed.

  转鼓的最大应力位于靠近大端鼓底的柱形筒体的内壁上，并且转鼓的最大应力强度和最大径向位移均与转速的二次方成比例；

• on the single row angular contact bearings, radial load rating of bearing rings relative to each other purely radial displacement of the load of the radial component.

  对单列角接触轴承，径向额定负荷为引起轴承套圈彼此相对纯径向位移的负荷的径向分量。