片语

nominal resin content标示胶含量

resin n content树脂含量

resin mass content含胶量

wet resin content湿树脂含里

pf resin content酚醛树脂含量

fixed resin content树脂固着量

Edge Off Resin Content沖淡树脂含量

resin solid content浸胶量

dissoluble resin content可溶性树脂含量

英汉例句

• the correlation formula for calculating the resin content and curing degree of up frp were introduced.

  本文介绍计算聚酯玻璃钢树脂含量和固化度的校正公式，该公式对实际工作有一定的指导意义。

• the impregnating methods concerned in this paper have the advantages such as availability for different types of resin systems, prepreg with uniform resin content and higher producing efficiency, etc.

  本文所涉及的预浸方法具有如下优点：适于不同体系的树脂，预浸料树脂含量均匀，生产效率高等。

• in line with the engineering requirement of eifs, a lot of tests were conducted on the tensile strength, breakage elongation, alkali resistance and resin content of c and ar glassfiber mesh.

  结合建筑外墻外保温工程的要求，对中堿和耐堿玻璃纤维网布拉伸断裂强度、耐堿性、断裂伸长率和涂覆量进行了试验研究。

• methods of outward surface treatment on the vessel to improve uniformity of inner and outer resin content distribution is put forward along with the …

  实验证明 ，容器内外层树脂含量分布更为均匀后 ，容器的性能得到提高。

• the influences of the resin content and molding parameter on the air permeation of bipolar plates were researched.

  考察了树脂含量和成型工艺参数对双极板透气性能的影响。

• the resin content in timber of yunnan pine was mainly controled by hereditary substance, and also affected by the geographic variation of grow place.

  云南松木材的松脂含量主要决定于遗传因素，但又受生长地理位置变异的影响。

• the effects of resin content on the properties of paper-based friction material were studied.

  就树脂含量对湿式纸基摩擦材料的摩擦磨损性能和表面形貌的影响进行了研究。

• the results show that pf resin content mainly influence composite properties. with pf resin content less than 20%, the composite had fairly good conducting property.

  结果表明：酚醛树脂含量是影响复合材料导电性能与力学性能的主要因素，酚醛树脂含量低于20%时，材料具有较高的导电性能；

• the analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail.

  采用氧弹燃烧法配合氟离子电极对有机溶剂型和水溶性氟碳漆中氟碳树脂含量的分析方法进行了研究。

• the results indicated that the intensity ratio of beta-ray i/t0 was consistent with the resin content value.

  研究表明：射线透过涂胶纸强度和原强度之比（i/i_0）与树脂含量具有良好的对应关系；

• the effect of resin content and weaving type of the fabrics on mechanical properties of carbon fabric reinforced composites was studied.

  本文研究了织物编织类型及树脂含量对碳织物复合材料力学性能的影响。

• we has determined the bending strength of blockboard which has different core and different resin content , in order to study the factor which affects the bending strength of blockboard.

  通过对不同芯板材种、不同施胶量细木工板的横向静曲强度的测定，旨在研究细木工板横向静曲强度的影响因素。

• while high resin content of paint, although the smell, but the safety of environmental protection, so the paint smells great, doesn't mean high toxicity, the key to distinguish what is that smell.

  而树脂含量高的油漆，虽然气味大，但是环保安全，因此油漆气味大，并不意味着毒性大，关键要分清这是什么气味。

• this paper introduces an improved test of soluble resin content in epoxy preimpregnated dmd material.

  本文介绍了一种改进的环氧树脂预浸dmd可溶性树脂含量检测方法。

• experimental results indicate that bond strength of the adhesive is the best when resin content is sixty to eighty percent and time on reaction is one an.

  分析讨论了胶粘剂组成及各成分相互关系，并对增粘树脂含量和反应时间对胶粘剂粘接强度的影响进行了研究。

• the effect of resin content on the friction and wear performance of carbon friction material in wet clutch is discussed.

  探讨了树脂含量对湿式离合器碳质摩擦材料摩擦磨损性能的影响。

• compared with the original pulp, resin content of the treated ground pulp with lipase under optimum condition decreased by 52.58 % and strength of the treated pulp increased in varying degrees.

  在脂肪酶最佳处理工艺条件下，磨木浆与原浆相比，树脂含量下降了52．58％，而强度均有不同程度的提高。

• treatment of ground pulp with lipase was investigated to reduce resin content of pulp.

  本研究用脂肪酶对磨木浆进行处理，以降低浆料中树脂含量。

• the contact angle decreases with time elapsing in single experiment. the original contact angle tends to decrease with increasing epoxy resin content in a sample.

  结果表明，接触角随时间呈下降趋势，初始接触角随着试样中环氧树脂比例的增加而降低，温度对固化剂平衡接触角的影响较小。