2025-09-09 13:39 浏览次数 8
凹模
The upper die is usually attached to the ram of a forging press or a forging hammer, while the lower die is stationary.
顶模通常放在锻压机的撞头或锻锤上,而底模则是固定的。
and step 5, performing secondary stamping, rotating the lower die at 90 degrees, locating, and secondary cutting.
步骤第二次沖压加工,将下模座旋转90度,并定位,二次切割。
and a die (10) embedded in the lower die (9).
以及嵌入在下模(9)内的模具(10)。