adhesion force中文,adhesion force的意思,adhesion force翻译及用法

2026-01-09 09:15 浏览次数 12

adhesion force

英[ædˈhi:ʒən fɔ:s]美[ædˈhiʒən fɔrs]

[力] 附着力;粘附力

adhesion force 例句

英汉例句

  • TOP BEST-661 has high surface adhesion force on vacuum bag and a variety of tools. In the curing cycle it has excellent seal, and very easy to remove from the cold or heating surface after the curing.

    TOPBEST- 661密封胶带对各种真空袋及复合工具都有较高的粘着力,在树脂固化周期内具有优异的密封性,固化后非常容易从冷或暖的工具表面去除干凈。

  • METHODS Orthogonal design was used with the adhesion force as the index in the experiment.

    方法采用正交设计法,以黏着力为指标,对巴布剂基质配比进行实验研究。

  • The relative adhesion force of biofouling increases with the increasing of molecular weight and reduces with the increasing of content of silicone oil;

    附着生物的相对结合力随着硅油分子量的增加而增大,随着硅油含量的增加而降低;

  • The mechanism of the adhesion force changing with the relative humidity has been analyzed from the viewpoint of surface tension, van der Walls force, and basic bond forces.

    着重从基本界面力,即表面张力、范德瓦耳斯力和基本键合力的形成与变化,分析了二氧化硅表面粘着力随湿度的增大先增后减的原因,探讨了粘着力的产生机理。

  • In this paper, the viscosity, adhesion force and film properties of the acetate starches size are tested, and the test results are analysed.

    本文对醋酸酯淀粉浆液的粘度、粘着力及浆膜性能进行了测试,并对测试结果进行了分析。

  • It may be due to an ICAM 1 accumulation on the microvascular endothelial cells and thus an enhancement of adhesion force during the course of disease.

    这有可能是发病过程中ICAM -1大量表达于内皮细胞表面,导致内皮细胞-白细胞粘附增加的结果。

  • The deformation (P2) is sufficient to create a returning force that is greater than the adhesion force between the solidified imprinting material and the mold.

    该变形(P 2)足以产生一回复力,该回复力大于固化压印材料和模具之间的粘合力。

  • TOP BEST-665 has high surface adhesion force on vacuum bag and a variety of tools. It is cost-effective and shows excellent sealing performance.

    TOPBEST-665密封胶带对各种真空袋及复合工具都有高的表面粘着力、优异密封性,是一款高性价比的密封胶带。

  • The emulsion which is bright and transparent after film forming has good adhesion force to a plastic base material, and the adhesion force to PP, PE films is particularly excellent.

    本发明所述的乳液成膜后,光亮透明、对塑料基材有很好的附着力,特别是对PP、PE膜的附着力优异。

  • With the increase of the sintering temperature, the adhesion force of Ni electrodes enhances, and the square resistance decreases.

    结果表明,随着烧结温度的增加,镍电极附着力逐渐增大,方阻逐渐下降;

  • And the bogie is one of the major components of a vehicle, it transfer every kind of forces, and produce tractive force using adhesion force between wheel and rail.

    而转向架是车辆系统的主要组成部分之一,它传递各种载荷,并利用轮轨间的黏着保持牵引力的产生。

  • As adhesion force promoter is added in the jet ink, the adhesion performance on base materials such as glass, metal, polypropylene or polyethylene is increased.

    由于喷码油墨中加入了附着力促进剂增加了其在玻璃、金属、聚丙烯、聚乙烯等底材上的附着性能。

  • The adhesion force that the sodium lactate produce on the small size of quartz particles is much stronger, which could cause contact failure more likely.

    乳酸钠对小粒径石英颗粒粘着作用更强,更易导致触点失效。

  • The causes of polluting molds surface were analysed in this paper. The main adhesion force between the rubber particles of the molds surface and the substrate is van der Waals force.

    本文分析了橡胶制品模具表面污染的成因,并确定了模具表面的橡胶颗粒与基体之间的主要的吸附力是范德华力。

  • The process of laser coating of super fine ceramic powder is discussed, and the hardness, roughness and adhesion force to the substrate of the coating are investigated.

    介绍了激光熔覆陶瓷粉的工艺过程,并对熔覆层的硬度、粗糙度和熔覆与基底之间的结合情况进行了考察。

  • It is driven not by the adhesion force from the contact between wheel and rail, but by the electromagnetic force from reaction plate which is mounted in track.

    它不是由轮轨间的粘着力驱动,而是由安装在轨道的反应板产生的电磁推力驱动的。

相关热词