片语

casing string structure套管柱结构

casing string design套管柱设计

combined casing string组合套管柱

Technological Casing String工艺管柱

Protection casing Protection string技术套管

Casing Drilling String套管鉆井管柱

casing g string套管柱

casing test string套管测试管柱

pipe casing string双层混合套管固井技术

英汉例句

• A completion configuration in which a production casing string is set across the reservoir interval and perforated to allow communication between the formation and wellbore.

  一种完井结构，其中的生产套管柱下过储层层段并经射孔，以便在地层与井筒之间能够连通。

• In horizontal well, frontal side casing string is usual bearing pressure. In horizontal hole section, with the length of casing increase, the hook load is decreasing on the contrary.

  水平井的前端套管一般是承受压应力的，随着进入水平段的套管长度的增加，大钩载荷反而下降；

• In conventional casing string design, only casing strength is considered.

  传统的套管柱设计中，套管只进行强度设计。

• The adapter between the first casing string and either the BOP stack (during drilling) or the wellhead (after completion).

  在第一根套管柱和防喷器组(鉆井时)或完井后的井口之间的一个接头。

• The fullbore sliding sleeves cemented in the well casing string enable on-command opening and closing of each entry point in the completion hardware.

  固定在套管柱上的全井眼滑套能够按照指令完井设备上的每一个入口点进行开关。

• A full-sized length of casing placed at the bottom of the casing string that is usually left full of cement on the inside to ensure that good cement remains on the outside of the bottom of the casing.

  一根放置于套管柱最下端的全尺寸长度的套管，通常里面装满水泥，以确保套管外能够完全充满水泥。

• The authors analyze the forces on the casing string under high-pressure working conditions, and give relevant equations for calculation.

  分析了套管柱在高压工艺条件下的受力状况，并给出了计算公式。

• While designing the bottom structure of casing string for highly deviated Wells, whether or not to use the floatation collar depends on the running friction and casing buoyant weight.

  对于大斜度井设计套管柱下部结构时，根据计算套管下人的摩阻和套管浮重决定是否采用漂浮接箍。

• There are too many random probable factors affecting the choice of safety factors in casing string design.

  在套管柱强度设计中，影响安全系数的因素很多。

• A component installed near the bottom of the casing string on which the cement plugs land during the primary cementing operation.

  安装在套管柱底部附近的一个部件，在初次注水泥作业期间水泥塞坐放于其上。

• This paper is on the research of whole casing string, and has built the entire casing string nonlinear mechanics model.

  本文以整体套管串为研究对象，建立了整体套管串非线性力学模型。

• The subassembly of a wellhead that supports the casing string when it is run into the wellbore.

  当套管柱下入井筒时支承套管柱的井口装置配件。

• And the equation for calculating the maximum deflection of the casing string in a horizontal hole can be obtained...

  由此模型可得到水平井套管最大挠度的计算公式。

• A casing string that does not extend to the top of the wellbore, but instead is anchored or suspended from inside the bottom of the previous casing string.

  不延伸到井眼顶部的套管柱，而是锚定或者悬挂于先前已经下入的套管内。

• The casing bowl incorporates features to secure and seal the upper end of the casing string and frequently provides a port to enable communication with the annulus.

  套管头四通包括固定和密封套管柱上端的部件，并经常提供一个用于与环形空间连通的开口。

• The releasing one-way valve is used to release the pressure from the casing string and pick up the device properly.

  释放单向阀用于释放管柱内的压力使装置顺利从套管中提出。

• A wellhead component or a profile formed in wellhead equipment in which the casing hanger is located when a casing string has been installed.

  在套管柱安装后在放置套管悬挂器的井口装置中的部件或型面。

• An enlarged pipe at the top of a casing string that serves as a funnel to guide drilling tools into the top of a well.

  套管柱顶部的一根大口径管，形如漏斗，以引导鉆井工具进入到井眼的顶部。

• The model takes into account the effect of stiffness of the string element and the effect of casing string stabilizers, and makes smoothing and interpolation to the measured well inclination data.

  模型考虑了管柱单元体的刚性效应及套管扶正器的影响，同时对实测井斜数据进行平滑和插值处理。