once the profile creation is completed, the following similar text appears on the command prompt window
配置文件创建完成后,命令提示窗口中将显示以下类似文本
open your command prompt window and navigate to the project folder as you did previously.
打开command prompt窗口并导航到项目文件夹,就像 之前所做 的一样。
when in debug mode, these are displayed in a separate command prompt window as shown in figure 1.
当处于调试模式时,这些将显示在一个单独的命令提示窗口中,如图1所示。
closing the command prompt window that opens will stop the mongodb server.
关闭打开的命令提示符窗口将会停止mongodb服务器。
a nice, shining and black command prompt window opened in front of my eyes.
光标及黑色命令提示符窗口开在前面的我的眼睛。
note: the command prompt window may show different text than the above.
注意:命令提示符窗口可能会显示比上述不同的文字。
if you have a command prompt window open, make sure you are in the c:\mongo\bin folder and enter the following command: > mongo.
如果现在有一个命令提示符窗口打开,确认位于c:\mongo\bin文件夹中并输入以下命令:>mongo.
open a command prompt window (start>run>, enter cmd and press ok) and issue the commands in listing 1.
打开命令提示符窗口 (启动 >运行 >,输入cmd并按确定),然后发出清单1 中的命令。
a command prompt window will pop up.
会出现一个命令提示窗口。
open a command prompt window and switch to the c:\program files\ibm\rfid\dts directory.
打开一个命令提示窗口并切换到c:\programfiles\ibm\rfid\dts目录。