片语

fatigue reason analysis疲劳原因分析

fatigue invalidation analysis疲劳失效分析

fatigue fractographic analysis疲劳断口分析

fatigue relief analysis免除疲劳分析

a fatigue reliability analysis疲劳可靠性分析

fatigue quantitative analysis疲劳定量分析

fatigue performance analysis疲劳性能分析

Fatigue Reliability Analysis疲劳可靠性分析

fatigue fracture analysis疲劳断口分析

英汉例句

• And combined with the fatigue analysis of the dumping low-bracket, the commercial software based fatigue analysis process of automobile part is elaborated.

  通过以举升缸下支座分析为例，详细论述了以通用有限元软件和疲劳分析软件为平台，对汽车零件进行疲劳分析的过程。

• The problems were essentially resolved through fatigue analysis and optimization of the structure of feed bin of PTA pneumatic transmission channel.

  通过对PTA气送糟料仓的结构进行疲劳分析和优化，从根本上解决了其裂纹和焊缝撕裂现象。

• The fatigue analysis about the welded seam region where stress is concentrated is dis- cussed by a experience formula and the related measure is put f…

  运用经验公式对应力集中的焊缝周围进行疲劳分析，提出相关措施。

• The crane「s metal structure intensity calculation and fatigue analysis is a fully complicated problem.

  起重机金属结构的强度计算及疲劳分析是十分复杂的问题。

• In addition, the static analysis, modal analysis, transient analysis during its working process and fatigue analysis of the rear arm of the type of motorcycle were done.

  另外还对该摩托车的后摆臂进行了静力分析、模态分析、工作过程瞬态分析和疲劳强度分析。

• By using of S-N curve method or fracture mechanics method, the fuzzy reliability analysis methods of fracture under extreme load and fatigue analysis are also provided in this paper.

  给出了应用s-N曲线方法及断裂刀学分析疲劳模糊可靠性以及在极大载荷作用下断裂的模糊可靠性分析的方法。

• Therefore, detailed fatigue analysis must be done during the design of such platform.

  因此，设计此类平台结构时，不能用简化疲劳分析方法，而要进行详细疲劳分析。

• The static analysis, modal analysis, special condition analysis, transient analysis during its working process and fatigue analysis of the main frame were done.

  然后做了某摩托车车架的静力分析、模态分析、特殊工况分析、工作过程瞬态分析和疲劳强度分析。

• The approach to apply the combined theory of strength and stability into fatigue analysis is discussed.

  探讨了强度稳定综合理论用于疲劳寿命计算的方法。

• A new method for calculating amplitudes of the local stress and strain in the strain fatigue analysis of aluminum alloy members is presented in the paper.

  提出了一种在铝合金构件应变疲劳分析中，计算局部应力和应变变程的新方法。

• The fatigue analysis was carried out by using finite element method. And the analysis result was assessed.

  用有限元分析的方法对贮料罐进行疲劳分析，并对分析结果进行评定。

• As the fatigue analysis results shows that the exhaust system don」t meet design requirements, it is necessary to improve the exhaust system.

  由于疲劳分析结果显示并未满足设计要求，有必要对排气系统进行改进。

• Abstr: fatigue analysis of a monopole support structure of 2 MW offshore wind turbine is demonstrated. Spectral fatigue analysis approach is adopted.

  文章摘要：以某2MW近海风机单桩式支撑结构为研究对象，采用谱疲劳分析法进行了疲劳分析。

• The ANSYS software is suitable for the dynamic-analysis and fatigue analysis of offshore platform, and it is an effective tool in the platform design.

  ANSYS有限元软件可以方便地计算平台结构在波浪、海流载荷下的动力响应和疲劳寿命，是进行平台设计和校核的有效工具。