英语释义

1. blades that cut off hot strip steel while it is being rolled by moving with the strip at the moment of severing

片语

drum type flying crop shears滚筒式切头飞剪

disc flying shears圆盘式飞剪

drum type flying shears鼓轮式飞剪机

rotary y flying crop shears滚筒式切头飞剪

design of flying shears飞剪机设计

flying crank shears曲柄式飞剪

flying-shears control飞剪控制

eccentric flying shears偏心式飞剪

英汉例句

• the article describes the optimization of flying shears system for the technical revamping of a hot continuous rolling mill.

  对国内某钢厂热连轧机飞剪进行技术改进，实现剪切的最优化。

• run-stop flying shears running course for one cycle is analyzed.

  具体分析了起停式飞剪的运行过程；

• flying shears equipment is one of the important continuously imported metallurgical equipment in china.

  飞剪机是我国长期以来一直引进的重要的冶金设备。

• the observed data for the shop measurement of a pair cf rocking flying shears at a certain steel mill are compared with calculated results from a computer.

  本文介绍对某钢厂剪切钢板的摆式飞剪的实测结果，并将其与电算结果加以比较。

• the key problem for drum-type flying shears is taking what specifications in designing a uniform speed non-knuckle gear and using what calculating method of its pitch curve.

  设计什么性能的匀速非圆齿轮及其节曲线的计算方法是滚筒式飞剪的关键问题。

• a succinct and practical method for calculating mechanical parameters of flying shears is obtained.

  对飞剪机的力能参数的计算提出一简洁实用的计算方法。

• since rocking flying shears are often subjected to strong inertial forces, very large shock loads are imparted to the moving parts in the shears.

  摆式飞剪由于惯性力较大，使得设备各运功部件承受很大的沖击载荷。

• this article mainly describes the cutting principle on mechanism, electrical unit and control for herr-voss eccentric flying shears as well as its mechanical and electrical structural features.

  主要介绍了h err-vo ss偏心式飞剪的机械、电气及控制的剪切原理，以及其在机械、电气方面的结构特点。

• in this paper, some detailed analyses were made and mechanism schematics were given for flying shears of three generations imported from abroad by a large-scale iron and steel enterprise.

  对某大型钢铁企业引进的三代飞剪机进行了较为详尽的分析，给出了三代飞剪机的机构简图。

• setting main parameters of disc flying shears are presented in detail. including cut angle, bite conditions, amount of scissors overlapping, friction coefficient and rolling speed etc.

  详细介绍了圆盘式飞剪各主要参数的确定，包括交角、咬入条件、剪刃重叠量、摩擦系数、轧制速度等。