片语

fracture interaction mechanism裂缝干扰机理

falling dart fracture toughening mechanism落锤沖击断裂韧性

fracture etching mechanism造缝机理

fracture discrete mechanism裂缝离散化机制

Fracture Generation Mechanism造缝机理

fracture propagation mechanism裂缝扩展机理

fatigue fracture mechanism疲劳断裂机理

fracture formation mechanism裂缝形成机理

Fracture failure mechanism断裂破坏机制

英汉例句

• The fatigue test method, the fatigue fracture mechanism and the basic theory of fatigue design are introduced in this course.

  本课程主要介绍疲劳试验方法、疲劳断裂机理和疲劳设计的基本理论。

• Mechanical properties and fracture mechanism of high strength steel sheet with low yield ratio under impact loading have been studied through instrumented impact and quasi-static tensile tests.

  通过室温下的仪器化沖击试验和静态拉伸试验，研究一种低屈服比高强度钢板在沖击载荷下的力学性能和断裂机理。

• HUANG Ming-li. Research on fracture mechanism by of interaction of multi2crack in brittle rock[D]. Shenyang: School of Resources and Civil Engineering, Northeastern University, 2000.

  黄明利。巖石多裂纹相互作用破坏机制的研究[D]。沈阳： 东 北大学资源与土木工程学院， 2000。

• Based on the existing research results and up to the minute theory of rock damage and fracture mechanics, the blasting damage and fracture mechanism of rock and bedded composite rock is studied.

  本文基于前人的研究成果，采用巖体损伤、断裂理论的最新研究成果，研究了巖石和层状复合巖体在爆炸应力波和爆生气体作用下的损伤断裂机理。

• The relationship between the phase structure, the impact fracture mechanism and the impact strength of the blends was investigated.

  研究了共混体的相结构、沖击断裂机理和沖击强度之间的关系。

• From the fracture mechanism of fiber concrete structure, some formulations as to the strength of fiber concrete are educed in the paper.

  从纤维混凝土的破坏机理出发，推导了纤维混凝土抗拉强度的计算公式。

• The advances of researching rock failure and hydraulic fracture mechanism by energy method are introduced.

  介绍我国应用能量原理研究巖石破坏机制及巖体水力劈裂机制的进展。

• The abrasion mass decreases at first, then increases. The fracture mechanism of the MMC transforms from ductile fracture into brittle fracture.

  该复合材料韧性降低，使其断裂形态从塑性断裂转变为脆性断裂。

• The cavitation behavior and the fracture mechanism under superplastic deformation are analyzed too.

  并对超塑性变形过程中的孔洞行为与断裂机理进行了研究。

• The interface of ECF-FGS was also characterized by SEM, and the fracture mechanism of the composite was discussed.

  利用SEM等分析测试手段研究了膨胀炭纤维和柔性石墨基体的界面状况，并探讨了复合材料的断裂机理。

• Weld fracture components were analysed by SEM and EDS, joint defect and fracture mechanism were also researched.

  利用扫描电子显微镜和能谱分析(EDS)对焊缝断口进行成分分析，研究焊接接头的焊接缺陷及断裂机制。

• The properties of same material is also different at the condition of different heat treatment, and the fracture mechanism is very different.

  同一种材料在不同热处理条件下，性能也不同，其断裂机理也有很大差别。

• The fatigue fracture mechanism of main bearing cage is analysed and investigated for aircraft engine taking WP6 for example.

  以WP6发动机轴承为例，对航空发动机主轴轴承保持架疲劳断裂的机理进行了分析探讨。

• Aims and meanings of reusing through crush of waste plastics were described. Specific properties and fracture mechanism in crushing and mechanical behavior of plastics were studied.

  阐述了废旧塑料粉碎再利用的目的和意义，对塑料的基本特性和塑料粉碎的断裂机理及力学行为进行了理论分析；

• The low temperature fracture mechanism of high manganese austenitic steels is studied.

  研究了高锰奥氏体钢的低温断裂机制。

• Interface breakage will be the main fracture mechanism if the interface bonding is weak because of the damage during the composites preparation.

  在复合材料中由于制备工艺或后期损伤导致的弱结合界面，界面破坏为主要的复合材料破坏机制。

• On the basis of above experiment, fracture mechanism of X60 over-heated HAZ was given using the theory of slip line field.

  在上述实验结果的基础上，采用塑性滑移线场理论，提出了X60过热区在不同服役温度下的断裂机理。

• In order to study the fracture mechanism of IC6 superalloy, the tensile process of alloy was observed by back scatter image in situ.

  为了研究IC6合金的断裂机制，用背散射电子图像原值观察该合金的动态拉伸过程。

• Through microscopic analysis of brass during high speed deformation, the deformation and fracture mechanism of brass under dynamic load are discussed.

  通过对高速变形的黄铜进行细观分析，探讨了动载下黄铜的变形和破坏机理；

• The characteristics of morphologies are helpful to judging loading mode sort, defining fracture mechanism of cast iron, so they are important means for the failure analysis.

  这种形貌特征有助于判别加载方式的类别，明确铸铁断裂的机理，是失效分析的重要手段。

• The authors also derive a theoretical model for describing the fracture mechanism &c. Some suggestions for prevention of fracture are also made in the article.

  文中对上述新方法系统的推导了理论公式，还对防止「虎口」处产生断裂提出了合理建议。

• The tensile fracture mechanism of cast A356-T6 aluminum alloy revealed a trangranular model(along the cell fracture) with quasi-cleavage feature.

  铸造A356-T6铝合金试样的拉伸断口显示其断裂为韧性断裂与脆性断裂的混和模式。

• The fracture mechanism and characterization of brittle materials like ceramics and glasses were investigated, and three models of crack evolution in failure process were pointed out.

  分析了陶瓷，玻璃等脆性材料的断裂机理和表征。指出了脆性材料的失效过程的三种不同的裂纹发展模式。