英语释义

1. a closed container in which a continuing cycle of evaporation and condensation of a fluid takes place with the heat being given off at the condenser end and which is more effective in transferring heat than a metallic conductor

片语

duct heater热导管

heat water pipe networks热水管网

heat-pipe type热管式

heat-pipe oven热管炉

heat-pipe cooler热管冷却器

heat transfer pipe传热管

heat insulation pipe隔热管

prefabricated heat preservation pipe预制保温管

Heat-pipe cooling热管冷却

heat-pipe fin热管翘片

英汉例句

• the model of operational mechanism is established to describe the steady state self-excited circulation flow of looped pulsating heat pipe (php).

  建立了环路型脉动热管稳态自激循环流动运行机制的物理模型和数学模型。

• the purpose of this paper is to probe into the impact of the bending angle of heat pipe on its thermal performance.

  本文之主要研究目的为探讨热管弯曲角度其热传性能的影响。

• qbasic was used to make procedure, structure of heat pipe was optimized with complex method on condition that the area of fixing heat pipe was invariable.

  利用该模型，采用复合形优化法，用qbasic语言编程，在安装热管的面积一定状况下对碳钢-水热管换热器的结构进行优化。

• at the same time, normal operation of wick ensures the uniformity of heat pipe circumference temperature, thus heat pipe receiver avoids phenomena of heat spot.

  另外热管吸液芯的正常工作使得热管周向温度分布均匀，从而避免热斑现象；

• an analytical model for the separate type heat pipe exchanger with three different fluids is presented.

  提出一个三流体分离型热管换热器的传热分析模型。

• the working principles, structure, and heat transfer characteristics of the gravity heat pipe heat exchangers, and their application in production of pyromellitic dianhydride anhydride were presented.

  介绍了重力热管换热器的工作原理、结构和传热特性，以及重力热管换热器在均苯四甲酸二酐生产中的应用情况。

• therefore it is very necessary to carry out research on corrosive problem of heat pipe ggh and find measures for engineering application.

  因此非常有必要对热管式ggh的腐蚀问题加以分析研究，以期能对实践有一定的指导作用。

• after presenting the initial design of a heat pipe oil cooler which is used to renew the shell-and-tube oil cooler the paper describes its reasonableness and economy.

  并且就电厂换热设备之一的管壳式冷油器更新为热管式冷油器的初步设计论述了其合理性和经济性。

• the artificial neural network method was used to anticipate the terminal temperature of the heat pipe network, and the diagnosis can accord to the anticipation result.

  绕过传统的通过求解微分方程确定温度的方法，利用人工神经网络来预测管网系统的终端温度，从而为供热管网终端泄漏诊断提供参考依据。

• vibration waste heat recovery using fluidized bed drying, therefore, the design of heat pipe air preheater, clean air heated to 100 degrees celsius to dry materials.

  振动流化床采用余热回收干燥，故设计热管式空气预热器，将干凈的空气加热至100摄氏度来干燥物料（略）。

• the evaporation model of micro heat pipe with triangular cross section was presented by analyzing both the heat transfer through the thin liquid film and the heat conduction along the heat pipe wall.

  通过对薄液膜蒸发传热以及热管壁轴向导热的分析，对三角形截面微型热管的蒸发段建立了蒸发传热模型。

• the new produced vapor bubbles are related with the existed vapor bubbles, and the scale effects on the startup and operation of looped pulsating heat pipe are found.

  已有汽泡的形状强烈影响脉动热管的启动和运行，小汽泡更利于新汽泡的产生。

• practical significance of heat pipe used as heat recovery equipment in air conditioning and ventilation system is introduced.

  介绍了设置热管热回收装置对空调通风系统节能具有重要的现实意义。

• the optimum buffer gas pressure for lif emission increases with the temperature of the heat pipe oven.

  使发射达到最大值的最佳缓沖气压随热管炉温度的增加而增加。

• the effect of heat source location on the heat transfer of an axially grooved heat pipe was investigated.

  探讨了轴向槽道热管垂直安装时热源位置的不同对热管工作特性的影响。

• this paper studies the competitive strategy of guangmang group of the vacuum tube collector with heat pipe (vtchp) solar water heater market by utilizing strategy management theories and methods.

  本文运用战略管理的理论和方法，研究光芒集团在热管式真空管（vtchp）太阳能热水器市场中的竞争战略。

• simulation results show that heat pipe receiver lightens system mass, improves heat efficiency of system and avoids phenomena of heat spot and heat relaxing.

  模拟结果表明，热管吸热器减轻了系统的质量，提高了系统的热效率，并能避免热斑和热松脱现象。

• based on some demands in thermal energy engineering and chemical industries, a new type of heat pipe was proposed and studied experimentally.

  根据热能工程及化工领域中的某些实际需要，提出了一种新型分离式可变热导热管并进行了实验研究。

• all of research results indicated that heat pipe heat sink for igbt can completely meet the thermodispersion request which is an effective method to solve the cooling of the power electronic module.

  各项研究结果表明：热管式散热器是完全可以满足散热要求的，是解决大功率电子模块散热的有效途径。