片语

programmed low idle speed低速空转控制的程序

idle-speed adfusting screw怠速调节螺钉

Low Idle Speed怠速

load speed负载速度；额定转速；空转速度

idle-speed hunting怠速游车

idle corrected speed慢车修正速度

idle-speed-enhancing valve怠速提升阀

idle speed adjustment空转调整

slow speed[物] 慢速，[物] 低速

英汉例句

• Under idle speed mode although emission volume consistency of pollutant is more bigger than other mode, the proportion of idle speed emission of the automobile isn't much.

  怠速法及双怠速法都是在怠速工况下检测待检汽车的排放污染物的容积排放浓度。

• He should also check ignition wires and connections, adjust idle speed and replace PCV valve.

  还应检查点火连线及其接头，调整空载速度，更换压力调节阀。

• By using the founded neural network model and DMC predict control algorithm, simulation research has been completed on the idle speed control in this pape.

  本文用已建立的发动机神经网络怠速模型，并采用DMC预测控制算法，完成了怠速控制的仿真研究。

• This paper describes the idle speed control stepper motor type composition, Stepper Motor Idle Control Valve on the main structure, Idle Speed Control Stepper Motor Control Principle of the device.

  主要介绍步进电机式怠速控制装置的组成，步进电机式怠速控制阀的主要结构及步进电机式怠速控制装置的控制原理。

• It may also be the first Chinese bike with fuel injection, which worked perfectly, adapting to dramatic changes in altitude and temperature, though the idle speed setting seemed off.

  它可能也是中国第一辆电喷摩托车，它能更完美的工作，更好的适应温度和海拔的剧烈变化，虽然它的怠速功能似乎关闭了。

• If the engine is running in an idle speed too long, spark plug might be serious carbonized.

  发动机长时间低速运行，可能导致火花塞积炭严重。

• Trying to warm up the engine at slightly above idle speed is actually doing the reverse and inviting additional problems.

  试图在热身略高于怠速实际上做反向，并邀请其他问题的引擎。

• This system has many functions such as distinguishing task control, short time overloading control, and automatic idle speed switch and overflow control.

  该系统具有分工况控制、期超载控制、自动怠速控制、流控制等功能。

• Electronic control of the vehicle engine includes electronic fuel injection, electronic spark control and idle speed control.

  发动机电子控制主要包括喷油控制、点火控制以及怠速控制等。

• By using the collection data in training the neural network, this paper establishes the proper engine idle speed neural network model.

  通过训练神经网络学习样本数据，建立了正确的发动机怠速神经网络模型。

• Analyzes the main factors affecting the toxic emissions from gasoline engine when it is at idle speed on the basis of forming mechanism of HC and CO in the engine.

  本文从未燃hc和CO在发动机内的形成机理入手分析了影响汽油机怠速排放污染物的主要因素。

• Abnormal sound only exists in idle speed or low speed operation to maintain a certain speed when the sound of the disorder, the rapid deceleration after a brief sound;

  异响仅在怠速或低速运转时存在；维持在某转速时声响紊乱，急减速时相继发出短暂声响；

• Therefore, the engine in various operating conditions to automatically adjust the idle speed is of great significance.

  因此使发动机在各种工况下能自动调节其怠速具有十分重要的意义。

• The proceedings of idle speed are so complex that it is very difficult to design a good controller based on the mathematical model of gasoline engine idling condition.

  由于发动机的怠速运转是非常复杂的一个过程，所以要在发动机怠速的数学模型的基础上来设计控制器是很困难的。

• The model of engine idle speed is the base of engine control.

  发动机怠速模型是发动机怠速控制的基础。

• The result of engine test shows that the DMC algorithm is adaptable for idle speed control of a gasoline engine and its stable and strong to resist interference.

  结果表明，DMC算法适用于发动机怠速控制，且具有稳定性好，抗干扰强等优点。

• The purpose of the idle speed control logic is to control engine speed at closed throttle.

  怠速转速控制逻辑是用于控制节气门关闭后的发动机转速。

• Experimental results show that the position of the converter nearer to the exhaust port, the retard ignition timing and the higher idle speed can promote the catalytic converter light-off.

  试验结果表明，催化转化器的位置距排气口近可提高排气温度，大大提高催化转化器的转化效率；推迟点火提前角和提高怠速转速均有利于使催化转化器进入快速起燃状态。

• He should also check ignition wires and connections, adjust idle speed and replace PCV valve. Attention to these service functions will improve engine performance and fuel economy.

  还应检查点火连线及其接头，调整空载速度，更换压力调节阀。注意上述维修工作将提高发动机性能并节省燃料。

• The effects of converter position, ignition timing and idle speed on catalytic converter light-off behavior were studied on an electronically controlled LPG injection engine.

  研究了电控LPG发动机的催化转化器安装位置、点火提前角和怠速转速对催化转化器快速起燃的影响。

• It is must to keep the engine at idle speed before the engine lubrication oil pressure is forming.

  在发动机润滑油压力建立以前，必须使发动机保持在怠速状态。