片语

impact reacting force function碰撞反力函数

impulse force[力] 沖击力

impulse of impact force沖力脉沖

maximal impact force沖击力

external impact force外力沖击

avalanche impact force雪崩沖击力

impact milling force沖击破碎力

impact t force沖击力

impact contact force沖击接触力

英汉例句

• according to the estimation, the impact force from india plate to china′s continent is the maximum, and then is the underthrusting force from philippine sea plate to china′s continent.

  表明印度板块对中国大陆碰撞力最大，其次是菲律宾海板块对中国大陆的俯沖力。

• a special impact experimental device and measurement system for vehicle models landing is established that makes real - time record of impact force , impact time and impact rate of models carry out.

  介绍自行研制的用于模拟航天器着陆的撞击试验装置和测试系统。

• one of the accident of wire line squeeze and disorder is caused by the impact force happened on fast line during rig starting.

  鉆机启动过程中的沖击载荷造成快绳拉力过大是钢丝绳在滚筒缠绕过程中发生夹绳、乱绳事故的主要原因之一。

• dynamic resisting force of pile and impact force are solved by mode-superposition method.

  文中利用振型迭加法求解桩顶动反力及撞击力，文末对有关影响因素进行了分析。

• when the runners were braless, their strides changed; they landed more heavily, with more of the impact force moving through the inside of their feet.

  当跑步者不着胸衣时，她们的步幅会改变；她们踩地力量更大，通过双脚释放更多的压力。

• the impact force considering the elastoplastic deformation of structures can be far less than the elastic result. this new method matches the practice better.

  考虑结构弹塑性特性后，沖击压力计算结果小于弹性沖击压力，更符合实际情况。

• the relation between lagrange multiplier of impact and impact force was obtained on the basis of theorem of motion of mass center.

  通过质心运动定律和绕质心的转动定律得到刚体非定轴转动的动能定理，并对两道力学习题作了分析和讨论。

• the instantaneous impact force is linear with impact distance, and depends on the difference in tension between descending and ascending vessels and the elastic coefficients of hoisting ropes.

  结果表明：防撞梁的瞬态沖击载荷不仅与沖击距离呈线性关系，而且和提升容器下降侧与上升侧的张力差、提升钢丝绳的弹性系数有关。

• because of this, detailed analysis was conducted on stress field at the time when impact force attended its maximal value.

  在此基础上对沖击力达到极值时的应力场分布做了详细的分析。

• the effects of impact energy and impact times on the green density, the maximal impact force and the withdraw force of specimen were investigated.

  研究电解铜粉高速压制成形工艺，探讨沖击能量、压制次数对生坯密度、最大沖击力和脱模力的影响。

• the research of intensity, rigidity, the stability, critical energy and critical impact force belongs to the fields of structure impact resistance, which the structure is struck in the impact load.

  结构受沖击作用下的强度、刚度、稳定性、临界能量荷载和临界沖击力的研究属结构耐撞性研究范畴，由于结构在沖击作用下的响应是一个复杂的非线性力学问题，目前该研究领域还比较弱。

• based on the dynamic model, the effects of the entrance velocity of the balls and the material density on the impact force and the contact time are analyzed.

  在此基础上分析了滚珠的入口速度、材料密度对碰撞力大小、接触时间的影响。

• anti-torsion design with high strength is able to withstand the stress and impact force of loading.

  高强度抗扭设计，能抵挡装载应力及沖击力。

• the test results show that the velocity and acceleration of the antenna nodes, also the impact force on the satellite are reduced efficiently after the control method was taken.

  试验结果表明，通过所施加的控制方法，有效地减小了天线节点在展开过程中的速度、加速度，从而降低了天线对星体的沖击力，验证了控制方法的可行性。

• a new precise actuator with 2 degrees of freedom for translational and rotational motions actuated by the impact force of an end-loaded piezoelectric bimorph cantilever was proposed.

  研制了一种以自由端带有集中质量的悬臂式压电双晶片为驱动单元、具有移动和旋转二自由度的惯性沖击式精密驱动器。

• the dth percussion-compact drilling is a high efficiency technology drilling in soil strata, which use the impact force produced by hammer piston to crush and compact soil.

  潜孔锤沖击挤密鉆进技术集沖击鉆进、振动鉆进及空气鉆进的优点于一体，鉆进效率高，成孔质量好，在土质地层鉆进工程中有着广阔的应用前景。

• the results show that the maximum impact force and the impact energy for pbga assemblies reflowed in nitrogen ambient is higher than those reflowed in compressed air.

  结果表明，采用氮气保护再流焊工艺得到的pbga组装板的最大弯曲试验载荷和沖击功比采用压缩空气对流再流焊工艺的组装板要高。

• maximum impact force is the greatest impact force (in inch-lbs) applied that did not cause visible damage or deformation to the test specimen surface.

  最大撞击力是指应用在测试样品表面上但没有出现肉眼可观测到损伤或变形的最大撞击力（单位：英寸磅）。

• in the jacking point, the water flow approximation, the impact force is big, can not meet the flow outside the flow, the defense is difficult.

  在顶沖点，水流逼近，沖击力大，无法迎托水流外移，防守困难。

• thorough understanding of impact force of motor is achieved through analyzing the overload mechanism of armored face conveyor.

  通过分析刮板输送机的过载机理，对电动机沖击力矩有了更深入的认识。