片语

high energy impact contact load高能量沖击接触载荷

impact heat load沖击热负荷

impact dynamic load沖击动载

impact landing load硬着陆载荷

impact t load沖击载荷

impact allowance load允许沖击载荷

impact contact load沖击接触载荷

impact rectified load沖击性整流负载

shock load沖击荷载

英汉例句

• in odontoid chain drive, the chain bears a periodical alternating load, in which the impact load produced while the link meshes into the tooth of sprocket makes comparatively big effect.

  在齿形链传动中，链条承受周期性的交变载荷，其中链节啮入轮齿时产生的沖击载荷影响较大。

• an approach for simulating damage process of prestressed reinforced concrete structures under impact load by applying the discrete element method is presented.

  采用离散单元法模拟了预应力钢筋混凝土梁在沖击荷载下的破坏过程 。

• the process of flat plates impacting water is analyzed based on ansys/ls-dyna software and especially the dynamic responses under the water-entry impact load are mainly discussed in this paper.

  采用ansys/ls-dyna有限元分析软件数值模拟入水沖击问题，重点研究平板类结构体入水沖击数值仿真和沖击荷载作用下的结构动力响应；

• the results show that, the larger the separation between stem and acetabular cup is, the greater the impact load is and the nonlinear relation between them is present obviously.

  结果显示，股骨柄与髋臼杯之间的分离量愈大，所产生之沖击负荷也就愈大，它们之间呈现非线性的关系。

• apply die-casting machine, injection molding machine and metallurgical, mining enterprises, strong impact load equipment or used under high temperature conditions.

  适用于压铸机、注塑机及冶金、矿山企业的重负荷、强沖击设备或高温条件下使用。

• the test result shows that the dynamic load factor of the suddenly applied load such as the inertial load and the impact load is larger than 2, and so cannot be ignored.

  测试结果表明：惯性载荷和沖击力等突加载荷的动荷系数都大于2，因此是不能忽略的。

• according to the problem that the impact load generated by large steel industries affects the area load curves, the paper introduces a method to pre-process the impact load using wiener filtering.

  针对大型特种钢铁企业所产生的沖击负荷影响地区负荷曲线的问题，介绍了一种利用维纳滤波对沖击负荷进行预处理的方法。

• internal bolts subject to vibration, fluctuating load, impact load or dynamic load shall be protected against loosening. double nuts, unti-loose washers, tack welding, etc. shall be used.

  可能受到振动、波动载荷、沖击载荷或动力载荷的内部螺栓应加以保护防止松动。可采用双螺母、防松动垫圈、点焊等。

• dynamic character of oil testing pipe shock absorber system under impact load were searched which were based on finite element analysis software ansys in this paper.

  本文基于有限元分析软件ansys 研究沖击载荷下石油测试管柱减振系统的动力学性质。

• this paper analysed the effect of impact load on deployment particularity of a double extended nozzle.

  分析了沖击负载对双节套筒式延伸喷管展开特性的影响。

• the problem of dynamic initiation for crack-containing plate of i-mode under low-velocity impact load is investigated in this paper.

  研究了含裂纹板在低速率沖击载荷作用下的互型动态起裂问题。

• with increase in electronic package density, the reliability of a board-level package under drop impact load becomes a key issue.

  随着微电子封装密度的提高，板级封装在跌落沖击载荷下的可靠性成为人们关注的焦点。

• the experiment results showed that the two-phase anaerobic technology possessed stable and high removal rate, and stronger ability to resist impact load than common anaerobic devices.

  实验结果显示：二相厌氧反应器具有稳定的高去除效率，且承受沖击负荷的能力明显高于普通厌氧装置。

• for the rigid steel frame, the impact load of different impact site varies little. the peak of the impact load is slightly higher when the impact site is in the 1/4 span.

  对于刚性钢框架来讲，不同的沖击部位对沖击荷载的影响不大，沖击部位在跨1／4处相对于在跨中时，沖击荷载的峰值略有提高；

• the calculation of settlement quantity of the fondation consolidated by impact load may be used to forecast some indexes of the improvement effect of the foundation.

  沖击荷载加固地基，场地地基下沉量的计算可用于估计其它地基加固效果指标。

• as the beam of the steel frame is impacted, the impact load is linear to the increasing impact speed.

  刚性钢框架梁在受到外界沖击物作用时，沖击荷载基本按沖击速度的增大线性变化；

• for chemical explosions in vessels, determination of impact load on inner-wall of vessels is the basis of their structural dynamic analysis, safety evaluation and engineering design.

  在容器内实施化学爆炸时，容器内壁上沖击波载荷的确定是进行爆炸容器结构动力响应分析、安全评估和工程设计的基础。

• in the selection of rolling bearing's types and models, some selected bearings can not be applied to the actual working environment, suffered the impact load in excess of the allowable load.

  在滚动轴承类型和型号的选择过程中，会经常出现所选用的轴承不能适用于实际的工作环境，其所受的沖击载荷超出了该轴承的许用载荷。

• the 16 steel tube-confined concrete short columns are selected and their dynamic response under axial impact load are studied.

  对16根钢管混凝土短柱进行了轴向沖击试验研究。