片语

peak forward current rating正向最大额定电流

repetitive peak inverse current[电子]

peak withstand current test电动稳定性试验

peak withstand current[电] 峰值耐受电流

Peak Repetitive Current输出参数

peak output current峰值输出电流

peak pulse current峰值脉沖电流

peak dark current[电子]

peak making current峰值接通电流

英汉例句

• It is pointed out, while expounding the principle of chopper speed variation, that the value of peak current can affect the service life of components and so it is necessary to control.

  文章阐述了斩波调速原理，指出峰值电流的大小会影响元器件的寿命，所以有必要对瞬时电流的大小进行控制。

• The effects of pulse peak current density on the texture and hardness of electrodeposited Ni were investigated.

  考察了脉沖峰值电流密度对纳米晶镍镀层织构和硬度的影响。

• The differences in the peak current observed at different areas are about 50% for natural downward strokes.

  不同地区下行自然闪电回击电流峰值存在最大约50%的差异；

• Based on the research on modern power supply technology, a peak current mode PWM controller chip were proposed.

  论文在研究开关电源技术发展现状基础上，提出一种峰值电流控制开关电源p WM控制芯片的设计。

• Near the critical point of the RLC-circuit, the residual voltage waveform changes form non-oscillating attenuation mode to distinct across zero oscillating mode when the peak current increases.

  在RLC回路临界点附近，随着沖击电流峰值的增大，残压波波尾从非振蕩衰减过渡到大幅度的过零振蕩；

• The arc length was taken as the manipulated quantity in the system and the peak current width of welding pulse was varied.

  该系统以弧长作为操作量，改变每个周期的脉沖峰值电流的宽度，以达到对焊接弧长控制的目的。

• Instability and reasons of peak current controlled BOOST converter are simply analyzed, basic principles of slope compensation and design problems are also expatiated.

  简要分析了峰值电流控制模式升压变换器的不稳定性及其原因，阐述了斜坡补偿的基本原理和设计问题。

• The design of the feedback compensator using the peak current control method and optocoupler insulation is analyzed in details.

  详细论述了采用电流峰值控制和光耦隔离系统时，其反馈补偿回路的设计方法。

• This paper introduces the theory of slope compensation and presents a piecewise linear slope compensation circuit for peak current mode boost DC-DC converter.

  结合一款升压型直流-直流变换器，介绍了峰值电流模式中的斜坡补偿基本原理，提出了一种分段线性斜坡补偿电路。

• A critical current mode based on the peak current control technology to achieve switching power supply power factor correction task is proposed.

  提出了一种基于临界电流模式的峰值电流控制技术来实现开关电源的功率因数校正任务。

• The oxidation peak current for pyrogallol at the MWNT-modified GCE increased significantly compared with that at the bare GCE.

  与裸玻碳电极相比，焦性没食子酸在MWNT修饰电极上的氧化峰电流显着增加。

• Lamp Current Crest Factor: Ratio of peak current to the root mean square lamp Current.

  灯管电流峰值因数：峰值电流与灯管电流平方根的比值…

• When the electric pulse is applied during the crystallization process, the time of the crystallization is also cut down, and the bigger the peak current is, the shorter the crystallization time is.

  在溶液结晶过程中施加电脉沖也可明显降低溶液析晶的时间，且脉沖峰值电流越大，析晶时间越短。

• Cyclic voltammetry was also used to study the effect of content of cupric ions and arsenic ions on peak current density and peak potential of cyclic voltammetry graphs of copper electrodeposition.

  并用循环伏安法研究铜砷共沉积过程中铜离子浓度、砷离子浓度等因素对铜沉积过程峰电流密度和峰电势的影响。

• There are DC off-sets in the compensated source current of the traditional APF with one-cycle control due to the existent ripple and the peak current detection.

  传统的单周期控制有源电力滤波器以峰值电流检测的控制方式和纹波电流的存在导致补偿后的电源电流中含有直流分量。

• Principles and virtues of switching power supply of peak current control are presented.

  介绍了峰值电流控制开关电源的原理和优点。

• This paper presents the principles and features of switching power supply in the peak current control.

  介绍了峰值电流控制开关电源的原理和特点。

• The influence of peak current on finishing high-speed wire electrical discharge machining (WEDM) in gas and emulsion dielectric is studied.

  研究了在大气和乳化液两种介质中，峰值电流对高速走丝电火花线切割加工的影响。

• Instability and reasons of peak current control are also expatiated.

  阐述了峰值电流控制的不稳定性及原因。

• Higher the temperature, greater the anodic peak current of CV, and PANI film is more electroactive and has a higher electrochemistry ability of repositing energy on corresponding potential.

  温度越高，聚苯胺膜的峰值电流越大，电化学活性越强，聚苯胺在对应电位时的电化学储能能力越强。

• The discharge breakdown time, peak current as a function of charge voltage and buffer gas are obtained.

  得到了放电击穿时间、放电峰值电流随充电电压、不同气体介质变化的曲线；

• Thee-beam peak current is 7A measured behind a 6mm diameter e-beam window. The pulse duration (FWHM) is 6-8ns and the maximum electron energy is about 107keV.

  在直径为6毫米的电子枪窗口后测得电子束峰值电流为7安，脉沖的半峰宽为6～8毫微秒，最大电子能量约为107千电子伏特。

• Biggest positive the parameters associated with the lamp power rectifier current, the rated current value of the selected diode should be a peak current in ac bus at least more than 3 times.

  最大正向整流电流该参数与灯功率有关，所选二极管的额定电流值至少应是交流母线中峰值电流的3倍以上。

• Higher peak current densities resulted in the cracking of the outside edge of the pores.

  较高的峰值电流密度导致氧化膜的外边缘破裂；

• The peak current and pulse duration of single pulse determine the size and depth of discharge crater, so they determine the machining surface roughness and size and shape accuracy.

  放电单脉沖的电流峰值和脉宽决定了单个电火花蚀坑的大小和深度，从而直接决定了工件的加工表面粗糙度、形状精度和尺寸精度。