片语

punching die沖孔模，落料模

piercing and curring die沖孔翻边模

trimming and piercing die切边沖孔模

side piercing die凸模强度

simple piercing die[机]

drawing and piercing compound die拉伸沖孔复合模

piercing terrace die沖孔凸模

piercing-shaving die沖孔整修模

shaping and piercing die成形沖孔模

multilateral piercing die多孔沖模

perforating die[机] 沖孔模，穿孔模

英汉例句

• this paper explains the design of piercing die for steel tube, especially the manufacturing process using bench worker「s experience to reduce the manufacturing cost.

  介绍钢管沖孔模具的设计，如何利用钳工的操作技能来制造上、下沖孔模具，降低制造成本；

• sliver strip melt piercing die and manual feeding mechanism are introduced, the design and manufacture of die key parts are analyzed, as the result, working efficiency gets improved.

  介绍了银带熔体沖孔模和手工送料机构，分析了模具关键零件的设计和制造，提高了生产效率。

• give an analysis about the features of a welding seam pipe」s piercing, and introduce the design clew of the welding seam pipe's piercing die using an instance.

  分析了焊缝管沖孔的特点，通过实例介绍了该焊缝管沖孔模设计思路。

• the extrusion and piercing die was developed based on the technical analysis on the shaping characteristics of deep taper pipe with hole.

  针对带孔深锥形管件的成形特点进行了工艺分析，确定了成形方案，设计了锥形管挤压模和沖孔模。

• through the improvement of the piercing die for the wave-shaped cage, cage positioning became accurate, the position tolerances of rivet holes were ensured, and technical requirements were met.

  通过对浪形保持架沖孔模的改进，保持架定位準确，保证了铆钉孔位置公差，达到了工艺要求。

• introduced the characteristics of the gear box case, and determinded the reasonable forming process, designed the drawing die, the trimming die, the piercing die and the flanging die.

  介绍了变速箱壳体零件的工艺特点，确定了合理的工艺方案，设计了拉伸模、切边模、沖孔模、翻孔模，经生产验证，模具结构合理，生产的零件完全满足要求。

• the technical characteristics of no-female die piercing on pipe were analyzed and the key points in design of a practical no-female die piercing die were presented.

  分析了管材无凹模沖孔的工艺特点，提出了该类模具设计的要点。

• further, the structural characters, design thought, proceedings required attention and assemble process of this piercing die are introduced.

  并介绍了该对沖孔模具的结构特点、设计思路、应注意的问题和装配工艺性。

• the technological process for stamping the decoration part inside the car was analyzed. and the structure of the pressing and piercing die for the decoration part was mainly introduced.

  分析了车厢内装饰件的沖压工艺，着重介绍了车厢内装饰件压形切口模的结构。