片语

eight-plastic-hinge八塑性铰机构

Elasto-plastic Damage Hinge弹塑性损伤铰

plastic-hinge region塑性铰区域

plastic c hinge塑胶铰链

correct plastic hinge model修正塑性铰模型

refined plastic-hinge method改进塑性铰法

eight-plastic-hinge framework八塑性铰机构

plastic living hinge塑料铰链

英汉例句

• By summarizing domestic actual anti-seismic design method, steel of high-performance for anti-seismic is needed to achieve beam plastic hinge collapse mechanism which is required in the code.

  通过对我国现行抗震设计方法的简要概述，得出为了实现规范要求的钢框架梁铰倒塌机制，需要使用抗震性能好的钢材。

• In order to improve the inadequacy of the current strut model, a more reasonable model is applied based on the mid-strut plastic hinge theory.

  针对目前桿件力学模型存在的不足，基于桿中部塑性铰模型的思想提出了一个更加合理的力学模型。

• Studies indicate that the connection with welded haunch shifts plastic hinge away from the face of the column.

  加腋型节点的塑性铰在远离柱翼缘面的梁上形成。

• Besides, the behaviour of plastic hinge at the member end of RC frame in process of loading is discussed and the empirical formula for calculating the equivalent length of plastic hinge is also given.

  此外，还讨论了加载过程中钢筋混凝土刚架桿端塑性饺的性能，给出了计算等效塑性铰长度的经验公式。

• With the help of plastic hinge theory and collapse theory, the formulas for calculating strength failure load and the method for computing collapse load were established respectively.

  分别利用塑性铰理论和压溃理讨论了强度计算问题，提出了强度承载能力计算公式和压溃荷载计算方法。

• Two basic types of beam-to-column connections using idea of shifting away plastic hinge from column face as well as design requirements of reduced beam section(RBS) connections are expounded.

  此外，还介绍了塑性铰外移的两种基本形式以及狗骨式（RBS）连接的有关设计规定和适用条件，其设计方法可供我国工程设计人员参考。

• The negative plastic hinge line in the plate was evaluated by using variational approach, then an equation for calculating the ultimate load carrying capacity was developed.

  首先利用变分原理确定板的负塑性铰线方程，继而推导出极限承载力的表达式。

• The loci of plastic hinge line and the maximum load during first roof weighting are determined by using kinematical method, and the minimum span of roof key stratum is derived.

  利用机动法确定了老顶巖板初次来压时载荷的上限值和塑铰线的位置，得到了顶板巖体关键层的最小破断跨距。

• The position of plastic hinge will effect the direction and ability of moment redistribution.

  预应力框架中塑性铰形成的位置不同，弯矩重分布的方向和能力也不相同。