different models were used to fit the movement of wetting front, it is found that the polynomial function was a good model.
比较了不同模型拟合的滴灌条件下土壤湿润锋的动态变化,认为多项式模型的拟合程度较好;
a polynomial function supervising pid control method is proposed, which is based on genetic algorithms (gas) for real-time control process.
针对实时控制过程提出一种基于遗传算法的多项式函数监督pid控制。
it is proved that the complexity of the algorithm is the polynomial function of the scale of the system. a practical example is shown lastly.
文中证明了该算法的计算量与系统的大小呈多项式关系,并给出一个应用实例。
distributed load is regarded as polynomial function or uniformly distributed moment all ng the edge.
荷载采用了多项式形的分布荷载及均布边缘力矩。
methods of exploring the real number roots of a real coefficient polynomial function are procedurally given.
较程序化地给出了实系数多项式函数实数根的求法。
it is a combination of the least-square method and the matrix iteration method. in the calculation, the polynomial function is taken as the trial function.
在计算中应用了最小二乘配点法和矩阵迭代法,取多项式为试探函数。
in the paper, the quadratic polynomial function smoothing-method is used to smooth the sampling data, which is proved to be effective in filtering the high frequency noise.
采用二次多项式滑动平滑法对采样数据进行平滑,有效地滤除了信号中的高频噪声。
the distributed load is regarded as polynomial function or uniformly distributed moment along the edge.
荷载采用了多项式型的分布荷载及均布边缘力矩。
polynomial function was used for the design of tractor trajectory from start position to destination position.
为此,采用多项式函数进行了拖拉机从起始位置向目标位置行驶的行驶路径设计。
all these algorithms are efficient, because in each case their time requirement grows as a polynomial function (such as ) of the size of input.
所有这些算法都是可行、有效的,因为在所有的情况下她们的时间需求以输入规模的多项式函数(比如)增长。
at each candidate change point, a reasonable order of the polynomial function can be determined by once estimating.
对每个候选变化点,经过一次判断即可确定多项式的合适阶次。
the paper emphasizes on the methods of polynomial surface approximation which is part of numerical approximations, and analyzes the precision of polynomial function model through the measured data.
着重介绍了数值逼近方法中的多项式曲面函数模型逼近法,并通过实测数据对多项式函数模型的精度进行分析。
the experimental data of this work were correlated as a polynomial function of the temperature. the average and maximum relative deviation were 0.49% and 1.21%, respectively.
利用本文实验数据拟合了甲基叔丁醚饱和液相粘度方程,方程和实验数据的平均和最大相对偏差分别为0.49%和1.21%,可以满足工程实际应用.。
by comparing the results for the linear function and cubic polynomial function and the convergences of eigenvalue.
比较了线性插值函数和三次插值函数的计算结果和本征值的收敛性。