片语

rapid cooling of clinker熟料的快速冷却

rapid clinker cooling熟料快速冷却

temper rapid cooling亚调质处理

rapid d cooling快速冷却

rapid cooling treatment快冷处理

rapid steam cooling蒸汽快速冷却

the rapid vacuum cooling快速真空冷却

rapid pre-cooling快速预冷

英汉例句

• Localized heating from the welding process and subsequent rapid cooling induces welding shrinkage stresses along weld bead during welding thin-wall plate and causes structural buckling distortions.

  在薄板焊接中，由于局部加热和迅速冷却产生了沿焊缝方向的焊接收缩应力，而导致焊接薄板发生屈曲变形。

• However, the rapid cooling of austenite postpones dynamic transformation remarkably.

  但奥氏体快速冷却明显推迟了动态相变的发生。

• The prognosis of heatstroke is directly related to the degree of hyperthermia and the duration. Thus, early diagnosis and rapid cooling are crucial for the patient's survival.

  预后跟高体温的程度与维持时间有直接相关，及早诊断与快速降温对于病人的存活与否很重要。

• Through the production of on-site tracking and analysis and the reasons for the investigation, the leakage of the fan in the rapid cooling section of the annealing furnace was the main cause.

  针对马钢热镀锌板出现的脱锌现象，通过生产现场跟蹤、分析和原因排查，确定退火炉快冷段风机密封漏气是造成镀锌板脱锌的主要原因。

• The rapid cooling increases the productivity, while the uniform cooling improves plastic product quality.

  迅速冷却提高了生产效率，而均匀冷却改善了塑件质量。

• Vacuum cooling has been widely used as a rapid cooling method for vegetables, fruits cut flowers, and foods to improve their keeping quality.

  真空冷却是一种快速冷却技术，它被广泛应用在花卉、水果、蔬菜和食品的冷却降温。

• When tempered glass suffers rapid cooling of a certain extent, the internal tensile stress and compressive stress on the surface can offset due to opposite stress direction.

  钢化玻璃受一定的急冷温度时，其表面的压应力与张应力方向相反，相互抵消。

• The noncrystalline structure is achieved by relatively rapid cooling below what is referred to as the glass transition temperature, around 1, 000 degrees Fahrenheit for the soda-lime variety.

  它不结晶的结构往往是通过在玻璃化转变温度以下迅速冷却而得到，对于堿石灰玻璃而言，大约在华氏温度1000度左右。

• With this process the rate of cooling is the controlling factor, rapid cooling from above the critical range results in hard structure, whereas very slow cooling produces the opposite effect.

  热处理时冷却速率是控制要素，从高于临界温度快速冷却导致坚硬的组织结构，而缓慢冷却则产生相反效果。

• The supercooled austenite transforms into friable martensite layer during the following rapid cooling process, leading to cracking and spalling at wheel tread.

  过冷奥氏体高速冷却，几乎全部形成脆硬的马氏体薄层，造成踏面剥离。

• As a new technology of the areas of metallurgy and material research, the bar casting combine rapid cooling with deformation.

  条形材铸轧技术作为冶金及材料研究领域内的一项前沿技术，是一项将快速凝固和变形结合在一起的技术。

• She’s been researching a period of rapid cooling that occurred about 13, 000 years ago.

  吉尔研究了13000年前地球气温急速下降的一段时期。

• The two rapid cooling events may reflect two rapid uplift processes of the UHPM rocks during the exhumation history.

  超高压变质巖的二次快速冷却事件反映了二次快速抬升过程。

• The results indicate that the emerging surface crackle are due to the too rapid cooling rate.

  研究结果表明表面裂纹是因冷却速率过快所造成的。

• This paper intends to study the influence of rapid cooling time after rolling on the microstructure and mechanical properties of low-carbon steel.

  本文研究了轧后快冷时间对控轧低碳钢板组织和力学性能的影响。

• QUENCHING: The process of rapid cooling from an elevated temperature. The product is placed in contact with liquids or gases, usually oil, water, or air.

  淬火：指从某一高温快速冷却的过程。产品被放置于液体或气体中接触，通常是油，水或者空气。

• A method about improving the crack resistance of weld metal and reducing structure stress during welding process, i. e. hammering welds and watered rapid cooling after welding, was obtained.

  研究出了提高焊缝金属抗裂性能及降低焊接过程结构内应力的工艺方法——焊后捶击焊逢并浇水快速冷却。

• A tendency to harden by rapid cooling necessitates the use of preheat to remove the quench effect of cold metal, and to reduce the cooling rate.

  强化的趋势迅速冷却，有必要制定预热来消除冷金属淬火效果，并减少冷却速率。

• The present AFT age pattern is, therefore, basically controlled by the Cretaceous rapid cooling event but finally shaped through active faults.

  现今的磷灰石裂变径迹年龄格局基本上受控于白垩纪的快速抬升冷却事件，但最后为晚期活动断裂所定格。

• For example, in the process of Bread production, flake ice is used for rapid cooling to prevent fermentation.

  面包的生产加工过程中用片冰快速降温以防止发酵。

• The vacuum cleaners MISTRAL 802 is powered by by-pass motors, carbon brush type, providing a rapid cooling of the motor in case of overheating.

  MISTRAL 802吸尘系统是一个旁路电动马达，碳刷，当马达在过热的情况下迅速冷却。

• Temperature control system adopts intelligent temperature controller that can preestablish temperature curve and forced drainage system can implement rapid cooling operation.

  温度控制系统采用智能温控仪，可以预先设定温度曲线；强制排水系统可以实现快速降温操作。

• Laser beam treatment. Similar to electron beam treatment, laser beam treatment alters the surface properties by rapid heating and rapid cooling in a very shallow region near the surface.

  与电子束处理类似，激光束处理通过在靠近表面很浅的区域快速加热和快速冷却来改变表面性能。