片语

Reactor of Vessel反应釜材质

reactor pressurized vessel反应堆压力容器

nuclear reactor pressure vessel核压力容器

reactor pressure vessel support压力容器支座

reactor tank反应堆（器）槽

material for reactor pressure vessel反应堆压力容器材料

reactor pressure vessel反应堆压力容器

reactor pressure vessel rpv反应堆压力容器

Reactor Pressure Vessel Boundary反应器冷却水压力边界

reactor pressure vessel internals反应堆内部构件

英汉例句

• a nuclear reactor module includes a reactor vessel containing coolant, a reactor core submerged in the coolant, and a heat exchanger configured to remove heat from the coolant.

  一核反应堆模块包括容纳冷却剂的反应堆容器、浸没在冷却剂中的反应堆芯以及被配置为从冷却剂移除热的热交换器。

• if the temperature is high enough, the core slumps to the bottom of the reactor vessel and melts through it and onto the floor of the containment unit.

  如果温度高到一定程度，堆心就会落到反应堆容器的底部并将其熔穿，从而到达密封装置的底部。

• so, the next action needed is to get a set of pumps running to keep coolwater flowing into the reactor vessel and the consequent steam coming out.

  因此，下一项措施是需要安装一套水泵，它的运转能够将冷却水送入反应堆容器，生成蒸汽后再返出来。

• the reactor vessel is surrounded by a thick steel-and-concrete primary containment vessel, equipped with a water reservoir designed to suppress overheating of the vessel.

  反应堆由一个钢与混凝土构成的厚实外壳（第一层安全壳）保护着，另外还配有一个蓄水库，防止反应堆过热。

• sit: workers replaced the original analog control system for the pumps providing makeup flow to the reactor vessel with a digital system.

  工人用数字系统替换向反应堆压力容器提供补水的泵的模拟控制系统。

• at normal conditions you「re not expecting the reactor vessel to fail because it」s warm and hot but if you hit it with cold water it「s a problem.

  在正常的情况下，你不会期待,反应堆管道失效，因为它是暖和和热的,但是，如果用冷水你沖击它，那是一个问题。

• and the list is; reactor vessel integrity which as you probably realise now is reactor vessel embrittlement, pressurised water sump pump performance, we」ll look at that.

  这个例子是，反应堆槽的完整性就是,现在你们可能意识到的，就是反应堆槽,的脆化，压水式排水泵,的反应，我们观察它。

• 「the reactor vessel head could have failed between two and 14 months further out, that would have been a major loss-of-coolant accident, 」 says nrc spokesman scott burnell.

  那个反应堆容器的头可能会在2到14月内坏掉 并将成为主要的冷却液缺失意外.

• the reactor vessel constitutes the main part of pressure boundary of primary coolant.

  反应堆压力壳构成了主冷却剂压力边界的主体。

• removing the fuel from the tmi-2 reactor vessel was the heart of the cleanup.

  从tmi-2反应堆中移除核燃料是清理工作的核心。

• the loose part impact positions are located by analyzing signals from accelerometers mounted on the reactor vessel with signal pre processing, time frequency transforms, and neural networks.

  通过对安装在反应堆压力壳上的多个加速度传感器的信号进行采集，并经过信号预处理、时频变换、神经网络计算等过程，实现对核电站松动件碰撞位置的定位。

• then you have the reactor vessel and piping which is the primary boundary which has an eight to ten inch thick reactor vessel and three to four inch thick steel piping to contain the cooling water.

  你们会有反应堆糟和管道,它们是主边界,事故8到10英寸厚的反应堆槽,还有3到4英寸厚的钢管,那是用来装冷却水的。

• and so, these are some solutions that you might wanna think about if you're ever faced with this situation. the next issue, do you have any questions on the reactor vessel by the way before i go on?

  所以，这些是你们可能会想到的,解法，如果你曾经面对这个情况,下一个问题，你们对反应堆管道,有任何问题吗，在我们继续讲之前？

• and given that maximum detectable flaw size should you have a pts event would the reactor vessel fail? or have a crack provocation such that the likelihood of failure would be much higher.

  得到了最大的可检测裂纹尺寸,你们应该要有一个pts的事件，反应堆,管道会失效吗，或者会有破裂的激发,像是失效的可能性会高得多。

• so annealing is another solution to reactor vessel integrity issues if replacement is not an option.

  所以退火处理是另外解决反应堆管道,整体性问题的方法，如果替换不可行。

• uncontrolled, the extreme heat could melt through or crack the reactor vessel causing a possibly explosive release of dangerous radioactive materials into the atmosphere.

  如果反应堆燃料棒温度不加以控制的话，核反应堆的温度将超过一定程（2200度），可能会造成核燃料融化爆炸，使得危险的放射性物质进入大气层。

• the diagram of the reactor vessel internals is used as a reference.

  将反应堆容器与内部构件的简化图作为参考。

• we notice that the differences are that the water in the reactor vessel is not allowed to boil.

  我们注意到不同就在于,在反应堆管道的水是不允许油的。