片语

abrasion wear test machine耐磨试验机

dynamic wear simulation test动态磨损模拟试验

THRUST BEARING WEAR DETECTOR TEST推力轴承磨擦检测试验

wear abrasion test machine穿着磨损试验机

accelerated wear simulation test快速模拟磨损试验

wear-test machine磨损试验机

Wear Rate Test涂层摩损率测试

wear resistance test耐磨试验

try sth. on试穿（服装、鞋帽等）

try sth on试穿

accelerated wear off test快速磨损试验

英汉例句

• the relations among the normal objective test, the manikin test and the subjective wear test are discussed.

  探讨了服装舒适性研究的三类方法（常规容观试验、假人试验、主观试验）之间的关系。

• the data obtained by using the ms-ygp wear test device can serve as a useful basis for the type selection of industrial coal pulverizing mills.

  运用ms—ygp磨损试验装置测定的数据，可作为工业磨煤机的选型依据之一。

• a new type of pin-ring corrosive wear test device designed by oneself was introduced in the article.

  介绍了一种自行研制的销-环式腐蚀磨损试验装置。

• a vibratve wear test machine with a rotative disk which can be operated in dry or wet state was used to perform a series of simulative tests for controlling individual factor.

  然后，在自行研制的干、湿两用振回转盘式磨损试验机上进行了一系列控制单因素的模拟试验。

• wear and tear tests of the treated specimen are made by brinell wear test machine, and the relation between wear rate and mechanical property is set up.

  以上处理的试样经磨损试验，得到了磨损率和机械性能的一些关系。

• the abrasive wear test with different loads was carried for high chromium white cast iron on the wear test machine.

  对不同载荷作用下的高铬铸铁在耐磨实验机上进行了磨料磨损试验；

• choose two kind of polyethylene as plastisol for the shoe upper doubling. bring to pass for wear test and calculating economy effect in production. progress a new use area for polyethylene of china.

  选择两大类国产高压聚乙烯为鞋用合布热熔胶，进行实用试穿试验和实际经济效益分析，为国产聚乙烯开辟一个新的应用范围。

• the simulation test of heavy rail straightening has been completed on m200 wear test machine.

  在m2 0 0磨损试验机上对重型钢轨的矫直过程进行了模拟试验。

• the measurement of the friction is always one of the important components of the friction and wear test machine.

  摩擦力的测量始终是摩擦磨损试验机的重要组成部分之一。

• the paper covers introductions of ordinary rubber wear test methods and the standards for selecting test conditions.

  介绍最常用的橡胶磨耗试验方法和选择试验条件的标準。

• standard test method for ranking resistance of plastics to sliding wear in block-on-ring wear test (cumulative wear method) using micro-tribometer mod.

  标準试验方法排行抗性塑料滑动磨损块上环磨损试验（累积磨损法）利用微摩擦国防部。

• the measurement of friction force is important in the design of friction and wear test machine.

  摩擦力的测量始终是摩擦磨损试验机的重要组成部分之一。

• wear and tear tests of the treated specimen are made by brinell wear test machine, and the relation between wea…

  以上处理的试样经磨损试验，得到了磨损率和机械性能的一些关系。

• the wear test result shows that the wear mass loss increases with load increasing.

  磨损试验结果表明，表面时效硬化高速钢在不同载荷下，磨损量随载荷的加大而增大。

• this paper investigates the influence of bearing's surface finish and clearance on its wearability obtained by simulating tests. the method of the wear test and measurement are briefly described.

  本文介绍模拟试验中轴承表面光洁度和配合间隙与磨损的关系，同时简述了磨损试验和测量方法。

• by using a reciprocating sliding wear test machine, wear behaviors of natural teeth at different tetracycline stained extent opposite to the titanium alloy are studied.

  在往复滑动摩擦磨损试验台上以钛合金为对磨材料，考察了不同染色程度四环素牙的摩擦学性能，并与正常恒牙进行了比较。

• the tribological performances of nano-cu additive were tested in the condition of different loads by friction wear test machine.

  通过摩擦磨损试验机测试纳米铜添加剂在不同载荷下的摩擦学性能。

• in this paper, an intensive study on the friction and wear characteristics of different tool materials with titanium alloys was performed systemically by the friction and wear test device.

  本文通过摩擦磨损试验装置对不同刀具材料与钛合金对磨的摩擦磨损特性进行了研究。

• a to-and-fro wear test apparatus was devised to investigate the tribological properties of fresh swine thighbones under various lubrication conditions.

  自行设计了一种往复运动的摩擦磨损试验机，在该试验机上对新鲜猪股骨在不同润滑方式下的摩擦学特性进行了研究。

• the x-ray diffraction was used to determine the structure of the coating surface. at last, the shock abrasive wear test was performed.

  用x射线衍射分析方法测定了镀层表面结构并作了沖击磨料磨损试验。

• usually if the shoe lever is 1 & 2, will also conduct wear test sample. no need for level 3.

  通常，如果鞋子的级别为1&2，必须生产试穿样品。若级别为3 则没必要。

• the wear tests with ring on block wear test machine and corrosion tests were carried out.

  用环块磨损试验机进行了磨损试验 ，并进行了腐蚀试验。

• standard test method for ranking resistance of materials to sliding wear in block-on-ring wear test using micro-tribometer mod.

  标準试验方法排行电阻材料的滑动磨损块上环磨损试验用微摩擦国防部。

• all products need to experience the impact test, leakage test and sliding wear test and other tests, the safety, waterproofing and fluency are in the same industry-leading.

  所有产品需经历撞击试验、渗漏水试验和滑动磨损试验等测试，其安全性、防水性和流畅性在同行业中领先。