axial compression中文,axial compression的意思,axial compression翻译及用法

2025-08-10 21:17 浏览次数 6

axial compression

英[ˈæksi:əl kəmˈpreʃən]美[ˈæksiəl kəmˈprɛʃən]

轴向挤压

axial compression 片语

片语

axial direct compression load轴向直接压缩荷载

axial-compression column of reinforced concrete钢筋混凝土轴心受压柱

three-axial E compression test三轴压缩试验

axial force compression ratio轴压比

axial-compression ratio轴压比

axial l compression轴向压缩

axial center compression strength轴心受压

axial flow compression system机轴流压缩系统

axial symmetric compression轴对称压缩

axial compression 例句

英汉例句

  • at both 1 and 6 weeks posttreatment, changes in trabecular architecture, global stiffness and strength of vertebrae were quantified using micro-ct stereological analysis and axial compression testing.

    在1周和6周的治疗后,使用微型ct体视学分析和轴向压力试验测定脊柱骨小梁结构,总体刚度和强度。

  • the study aims to find out the proper limited values of axial compression ratio of the steel tube-steel concrete composite column under the condition of ductility damage.

    目的研究使钢管-钢骨混凝土组合柱发生延性破坏时所需要确定的轴压比限值。

  • based on the softened strut and tie model, the effect of axial compression ratio on seismic behavior of irregular interior joints is also discussed.

    在此基础上应用简化拉压桿模型方法就轴压力变化对异型节点受力性能的影响进行了初步分析。

  • according to researches on src column with steel circle pipe, the calculation methods of the axial compression ratio and load bearing capability of normal section are put forward.

    根据对配有圆钢管的钢骨混凝土柱的研究结果,介绍了配有圆钢管的钢骨混凝土柱的轴压比、正截面承载力的设计计算方法,并给出了工程应用的实例。

  • for special-shaped column composed of concrete-filled square steel tubes, research is done by three methods: superposition theory, finite element analysis and axial compression experiment.

    并结合方钢管混凝土组合异形柱的推广应用,对梁柱节点和维护墻体作法进行了探讨。

  • based on tests of two full-scale double-span prestressed frames, internal force redistribution of frame was studied and continuity of structures and axial compression ratio of column were analyzed.

    基于两榀接近足尺的后张有粘结预应力混凝土框架的试验,对多跨预应力框架的内力重分布进行了研究,重点考虑了框架的连续性和轴压比的影响。

  • first of all, we investigated the buckling behavior of filled (8,8) and (10,10) armchair cnts subjected to axial compression loading.

    在压缩模拟计算中,主要研究金原子填充(8,8)和(10,10)单壁碳纳米管中的情况。

  • design parameter analysis for the joints is carried out through finite element method so as to find out the influence of diaphragm thickness, extend length, axial compression ratio on joint behavior.

    进行了节点参数分析,通过有限元数值计算,掌握了隔板厚度、挑出长度及轴压比对节点性能的影响规律。

  • in the calculation of ultimate axial compression ratio for irregularly-shaped columns, the grid method is usually applied to the cross-section integration.

    采用简化的平行线法计算中和轴的位置,用有限元法对钢筋混凝土十字形截面柱界限轴压比进行分析。

  • the tensile strengths under different confining pressure can get by changing the axial compression force.

    通过改变轴向压缩载荷的数值,就可以得到不同围压下巖样的拉伸强度。

  • the main factors that influence the seismic behavior of rrc columns are the percentage of central reinforcement, equivalent ratio of axial compression and characteristic value of stirrups.

    核心配筋率、等效轴压比和配箍特征值是影响rrc柱抗震性能的主要因素。

  • the state space equations for vibration and stability of composite laminated beams under axial compression have been derived for arbitrary boundary conditions.

    建立了组合梁在任意边界条件下振动与稳定性的状态空间控制方程和振动频率与轴压载荷之间的相互关系式。

  • in 2005, the first dynamic axial compression column system & static axial compression column system with its independent intellectual property right in china was developed in our company.

    2005年,公司研发出了中国第一台具有自主知识产权的动态轴向压缩柱系统和静态轴向压缩柱系统。

  • four high axial compression ratio composite energy dissipation shear walls were used as specimens under low-cyclic recycled lateral loads in an anti-seismic ability experiment.

    榀高轴压比复合消能剪力墻在低周反复水平荷载作用下的抗震性能试验。

  • by muting certain requirements of ductility, the limit values of axial compression ratio of c80 srhc columns are put out, and the influence of stirrup ratio on it is also analyzed.

    在满足一定位移延性的基础上,提出了c80型钢高强混凝土柱的轴压比限值;并就配箍率对轴压比限值的影响进行了分析,进一步提出了与不同配箍率相关的轴压比限值。

  • the ductility of the specimens is decreased and the ultimate bearing capacity is increased by raising axial compression ratio.

    随着试件轴压比的提高,试件延性降低,极限承载力增加。

相关热词