片语

corresponding checking computation相应的验算

strength checking computation强度验算

practical checking computation实用算法

structural checking computation结构验算

checking computation of cracks裂缝验算

aseismic checking computation抗震验算

checking computation of strength强度验算

英汉例句

• Strength evaluation of concrete check and accept group should be figured out in terms of structure checking computation and remedy when needed.

  评定混凝土强度时应计算出强度评定值，作为结构验算和加固补强的依据。

• Introduces the checking computation about the time of belt conveyors started and the power of the motor when belt conveyors are started.

  给出了带式输送机启动时启动时间和电机功率的验算方法。

• This paper introduces a theoretic analysis of a flywheel in cutting-off machine for leftover material. It provides a precise design method and a mode of checking computation for the machine.

  对在滚筒式碎边剪机构上增加飞轮装置进行了理论解析，为所设计的机器进行提供精确设计和验算方法。

• It is pointed out that we shall give full consideration to the millisecond delay detonator「s error, design method and checking computation method on seismic wave.

  提出在爆破地震控制设计中必须充分考虑毫秒延时雷管误差的思想、设计方法与地震波的验算方法。

• Therefore, it is meaningful in practice that designs and calculates for open-cut foundation from two aspects which are bury length determining and checking computation contents of foundation.

  因此，从基础埋置深度的确定和基础的验算内容两方面分析明挖扩大基础的设计与计算，具有重要的实践意义。

• At the same time, the thesis design all hydraulic pressure system loop and checking computation the pressure losing in pipeline system, the changing temperature of hydraulic pressure system.

  同时，本文对整个液压系统回路进行了设计及其对管路系统压力损失、液压系统的温升进行了验算。

• From the condition of acceptability, the calculation of lateral earth pressure, and the checking computation of anti-sliding stability, etc.

  从适用条件、侧向土压力计算、抗滑移稳定验算等几个方面探讨了扶壁式钢筋混凝土挡土墻的设计。

• This paper, based on designing parameters of gold dredge and orebody」s occurrence parameters, introduces the checking computation of structural size of gold dredge.

  文中分析探讨了如何根据采金船设计参数与矿体赋存参数进行采金船结构尺寸验算。

• By comparison with the measurement of the prototype and through the checking computation of record curves, this method is satisfactory.

  经标準样板测试对比和由记录曲线手算验证，本方法是可行的。

• This paper focuses on checking computation of thermotechnology in this stove.

  本文主要对该热风炉进行热工验证计算。

• Recommends to make checking computation after adjusting pipe diameter in order to reduce errors.

  建议对调整后的管径进行验算，以减少误差。