片语

Minimum Cure Time最少固化时间

short cure time治疗时间短

Full cure time全固时间

clinical cure time临床治愈时间

Best Cure Time最佳治疗时间

optimum cure time硫化时间

post-cure time后固化时间

process cure time程序固化时间

Top optimum cure time正硫化时间

英汉例句

• with the increasing of cure temperature, the scorch time and optimum cure time decreased, but the crosslink density had a tread of decreasing.

  硫化温度的提高会缩短焦烧时间和正硫化时间，但有使交联密度下降的趋势。

• the results indicated that the scorch time and cure time of sbr/ht composites shortened with the loading of ht. the thermal stability and mechanics properties of sbr/ht were also improved.

  实验结果表明，随着水滑石含量的增加，sbr／水滑石复合材料的焦烧时间和正硫化时间逐渐缩短且经过有机修饰的水滑石变化幅度更大，同时水滑石的加入也提高了橡胶的热稳定性和力学性能。

• the results show that with the increase of the amount of silica, the scorching time and optimum cure time of cr/tpi compounds are shortened.

  结果表明，白炭黑能加速cr/tpi并用胶的焦烧性能，同时降低了胶料的硫化速度。

• following the cure time for the repair product, as described above, the repair shall be re-tested.

  在上述修补产品固化后，应再次检查修补部位。

• results: compared with routine group, the purgation group has lower mortality rate, lower surgical operation rate and shorter average cure time than routine group.

  结果：常规组与中西医结合组在手术率、并发癥率、平均住院时间、死亡率方面存在显着性差异。

• the influences of cure temperature, cure time and ambient humidity on the properties of the dam blank were discussed.

  探讨了养护温度、养护时间和环境湿度对坯体性能的影响。

• the higher the temperature is, the longer cure time is, the larger volumetric expansion will be.

  并且苯并恶嗪的固化温度越高，时间越长，体积膨胀效应就越大。

• besides the scorch time and optimum cure time of biir were shortened considerably while its curing rate increased obviously.

  与丁基橡胶相比，biir焦烧时间和正硫化时间明显缩短，硫化速度大大提高。

• results there was a significant difference between the cure time of treatment, whether it would bleed during the operation and the cure condition after the operation. (p001).

  结果在治疗的痊愈时间上，术中是否出血及术后痊愈情况方面均存在着显着性差异，p。

• the influences of photoinitiator, crosslinking agent and cure time on the properties of uv curing pressure sensitive adhesive were discussed in the paper.

  在常温下涂布后直接紫外光交联固化，考察了光引发剂、交联剂、光固化时间等因素对uv固化压敏胶综合性能的影响。

• the coating manufacturer shall be consulted to ascertain the proper cure time and methods.

  需要咨询喷涂厂家确定适当的固化时间和方法。