片语

driving torque vector analysis转矩矢量分析

driving torque coordination驱动力矩调节

driving torque of rig[地质]

the largest driving force torque最大驱动力

joint driving torque关节驱动力矩

driving wheel torque驱动轮扭矩

cutterhead driving torque刀盘驱动转矩

instantaneous driving torque瞬时驱动扭矩

peak driving torque最大驱动扭矩

英汉例句

• this system is designed to test the transmission' clearance and driving torque and cut strength displacement in some kind of rudderpost automatically.

  本系统设计实现对某型号舵轴的传动间隙、驱动转矩以及剪切力位移的自动化测量。

• this paper describes the functional relationship between magnitude of single harmonic torsion vibration and its corresponding harmonic driving torque of internal combustion engine using energy model.

  利用能量模型推导出了多缸内燃机曲轴简谐扭振幅值与各缸力矩幅值间的函数关系式。

• the effects of structure deformations of wheelset and track on driving torque applied to a single wheelset of a high speed locomotive were investigated in detail.

  从数值方面详细分析了轨道结构变形对高速机车单轮对牵引力矩的影响。

• by analyzing the forces acting on the rolls of 6-h mill, a formula for calculating the driving torque and eccentricity is derived.

  通过对六辊轧钢机辊系的受力分析，给出了轧辊传动力矩和偏移距的计算公式。

• the rotating speed and torque are constant during rotation, as compared with cross-shaft coupler under the same radius of gyration, it raises the driving torque about 50%.

  传动时转速、转矩衡定，在同回转直径下比「十字轴式联轴器」提高传动转矩50％左右。

• the driving torque requirements for attitude control of a space vehicle are typically closely related to the mass moment inertia of the system.

  飞行器姿态控制的驱动扭矩与系统的转动惯量之间存在密切的联系。

• this paper discusses the influence of structural design, external magnetic field, input speed and torque on the driving torque of mrf coupling.

  讨论结构设计、外加磁场、输入转速和转矩对mrf联轴器传动扭矩的影响。

• to improve the driving torque and increase the inner space utilization rate of wheel hub motor on electric motorcycle, a double-stator permanent magnet motor was reported in this paper.

  为充分利用电动摩托车轮毂电机内部空间，提高电机的驱动转矩，该文设计了一款双定子结构的永磁电动机。

• in order to study the operating principle of tangential type turbine flow sensor, the rotor driving torque was deduced and the meter factor was given.

  为深入研究切向式涡轮流量传感器的工作机理，推导了流体对涡轮叶片的驱动力矩，得出切向式涡轮流量传感器仪表系数的数学表达式。

• calculation formulae of driving torque for each joint are derived based on lagrange dynamic equation, mathematical models for gait optimization are established.

  基于拉格朗日方程推导了各个关节驱动力矩的计算公式，建立了拟人机器人步态优化的数学模型。

• the result shows that an additional torque is brought in that will affect the transmission of the driving torque and intensify the abrasion and reduce the life of the components.

  结果表明这种传动轴在传递所需运动的同时，会产生附加力矩，影响力矩的正常传递，使得机构磨损加剧，寿命降低。

• the utility model has the advantages of compact structure, long service life, big driving torque and small loss of driving power and small maintenance ratio and can realize the replacement of gears.

  本实用新型具有结构紧凑、使用寿命长、传动扭矩大且传动功率损失小的优点，它可以实现挡位的更换，维修率小。

• it is analysised of some survey results of rotary kiln driving torque and revises the calculation formula now available.

  对回转窑传动扭矩的实测结果进行了分析，对现有的计算公式进行了修正。

• using the numerical calculus and derivation, the calculation model of system driving torque was established.

  通过数值计算和推导，建立了系统驱动力矩计算模型；

• a dynamics model of the robot is used to analyse the driving torque of each joint, and the driving power of motors are decided based on the analysis results.

  利用两足步行椅机器人动力学模型，分析了各关节的驱动力矩，以此确定了驱动电机的功率。

• the forces of the driving wheels are analyzed using parameters of the wheels and the driving torque is deduced.

  结合驱动轮参数对驱动轮进行受力分析，推导出该机器人驱动轮的驱动力矩。

• we measured the relation of driving torque of the motor and the phase difference of vibration of stator surface particles.

  另外，我们观测了两种摩擦材料的马达转动力矩与相位差的关系。

• furthermore, the adjustment, opening and closing of valve are controlled by the driving torque and actual loading torque.

  阀门的启闭或调节动作受控于所施加的驱动转矩与实际负载转矩。

• this carrier has better corrosion resistance, longer life time and lower driving torque as compared with conventional fe base shot carrier.

  与传统的球形铁基粉末载体比较，它具有耐蚀性好、使用寿命长和驱动力低等优点。

• it is also the characteristic that the driving torque on the wheel, acceleration and fuel consume change with the throttle opening and vehicle speed before and after shift.

  加速度、档位、油耗等，并且这些数据都保存到文件当中，便于事后进行处理分析。