英语释义

1. of, relating to, or resulting from flexure

2. characterized by flexure

片语

flexural plane挠曲线平面

Flexural properties弯曲性能

flexural cracking弯曲裂纹

flexural downbows挠曲下弯

flexural fatigue弯曲疲劳

flexural member[建] 受弯构件，挠性构件；挠曲桿件

flexural modulus[力] 弯曲模量；[力] 挠曲模量

Flexural Failure挠曲损坏

flexural strength挠曲强度

flexural rigidity[力] 抗弯刚度

flexural capacity受弯承载能力

flexural stiffness抗弯刚度；抗挠刚度

flexural spring弯曲弹簧

flexural stress弯曲应力；挠曲应力

英汉例句

• zirconia ceramics used in all-ceramic restoration of prosthodontics has shown favorable biocompatibility chemical stability flexural strength and color property.

  摘要氧化锆陶瓷作为口腔全瓷修复材料，在生物相容性、化学稳定性、抗弯曲强度和色泽等方面具有优势。

• in order to satisfy the requirements of both ultimate limit state and servicing limit state unbonded partially pre stressed concrete flexural members must be reasonably designed.

  为满足承载能力极限状态及正常使用极限状态的要求，必须对无粘结部分预应力混凝土受弯构件进行合理设计。

• in this paper, the behavior of the flexural rc member bonded with cfrp board on its vertical sides was investigated by the authors recently.

  本文研究采用在混凝土构件侧面粘贴碳纤维板这种新形式加固受弯构件的受力性能。

• the experiment research shows that the performance of flexural member reinforced with hrb500 steel bar is the same as that of the common reinforced concrete members.

  hrb500级钢筋混凝土构件的受弯性能试验研究表明，hrb500级钢筋混凝土构件受弯性能与普通钢筋混凝土构件相同。

• aim:to compare the compressive strength, tensile strength and flexural strength of bulkily filled and incrementally filled visible light-cured composite resin.

  目的：比较整体固化与分层固化光固化复合树脂的压缩强度、拉伸强度及弯曲强度。

• the growth of fibre content raises the values of flexural strength and flexural modulus, but has no contribution on shear strength.

  短炭纤维含量的增加，使复合材料的弯曲强度和弯曲模量随之增大，但对剪切强度没有贡献。

• by flexural test and split test , the effect of part or total replacement of mineral powder with cement on and-cracking performance of asphalt mixture is researched.

  通过弯曲试验和劈裂试验，分析了水泥替代部分或全部矿粉对沥青混合料抗裂性能的影响。

• in borehole sonic logging, these may be the shear, flexural and stoneley waves.

  在井眼声波测井中，这些波是横波、弯曲波、斯通利波。

• take the first cross section as an example, and the calculation formula of flexural capacity of composite beams is obtained by using the error transfer formula of mathematical statistics.

  运用数理统计学的误差传递公式，推导出了组合梁截面抗弯承载力统计参数的计算公式（以第一类截面为例）。

• according to performance of carbon fiber and its application in engineering strengthening, the formula of plane section strength and shear strength of flexural members are put forward.

  根据碳纤维布性能特点及在工程加固中的应用，给出锈蚀结构受弯构件正截面和斜截面承载力加固公式；

• the procedure to calculate the coupling matrix of plate junction considering both flexural and in-plane wave fields was presented.

  对考虑弯曲和纵波场耦合的板结构给出了计算能量有限元耦合矩阵的一般方法。

• objective: to compare two sorts of mental net reinforcement on the flexural strength of denture base resins to provide some data for the clinical application.

  目的：检测两种金属网对义齿基托材料抗折强度的加强作用，为义齿基托修复的临床选择提供理论依据。

• in this thesis, the storey deformations of frame-tube structures under lateral loads are divided into shear deformations and flexural deformations.

  将框筒结构在侧向荷载作用下的楼层变形划分为剪切变形和弯曲变形。

• the microstructure of bamboo was investigated and correlated with the mechanical properties of this material under tensile and flexural stresses.

  采用显微观察、拉伸和弯曲等力学测试方法，研究了竹材的微观结构和力学特性的关系。

• the relationship between nucleation temperature and flexural strength was investigated.

  探讨了核化温度与抗弯强度之间的关系。

• results showed that the flexural strength of esmc parts was different at different direction of fiber orientation.

  研究表明制品在各流动方向上的弯曲强度有很显着的差别。

• it is superior to common cemented carbide on properties, such as high hardness, fracture toughness, flexural strength and higher wear resisting property.

  相比于普通硬质合金具有更高的硬度、断裂韧性、抗弯强度及优异的耐磨损性能，具有广阔的应用前景。

• objective to study the effects of different treatment methods on the biaxial flexural strength of hot pressable ceramic.

  目的研究不同处理方式对白榴石增强陶瓷的双轴弯曲强度的影响。

• this is a long-drawn flexural journey full of challenge and expectation.

  这是一个漫长曲折，同时充满挑战与期待的旅途和征程。

• the beam has a constant flexural rigidity .

  该梁具有常数弯曲刚度。

• the calculation formula of flexural load capacity of steel beams is obtained by using the error transfer formula of mathematical statistics.

  运用数理统计学的误差传递公式，推导出了钢梁截面抗弯承载力统计参数的计算公式。

• steel-concrete composite beam is a kind of flexural member composed by concrete slab and steel beam via shear connectors.

  钢-混凝土组合梁是指钢梁和混凝土板通过剪力连接件连接形成整体共同工作的受弯构件。

• higher ethylene content, mass fraction of xylene soluble part in copolymer and higher intrinsic viscosity of this part had negative effects on tensile strength and flexural modulus of copolymer.

  提高共聚物中的乙烯含量、二甲苯可溶物含量或二甲苯可溶物特性粘数，共聚物的拉伸强度和弯曲性能降低；