片语

fracture limit strength断裂极限强度

high fracture strength高断裂强度

fracture failure strength model断裂破坏强度模型

rupture strength抗裂强度；断裂强度

fracture e strength抗断强度

break strength断裂强度

brittle fracture strength脆断强度

Fracture Failure Strength断裂破坏强度

fracture mechanics strength断裂力学强度

fracture initiation strength初裂强度

average fracture strength平均断裂强度

英汉例句

• fracture strength of meat ball increased slowly with tripolyphosphate contents increasing, but the fracture displace increased at 0.1% dosage and leveled off after that point.

  肉丸破裂强度随三聚磷酸钠添加量的增加而较缓慢地增加，其破裂点距离在高于0·1%的添加量后不再增加。

• the first one is used to deal with fracture strength of 3d braided cmc with weak interface and large braided angle by a semi-experiential method;

  界面失效模型用半经验方法处理弱界面和大角度的断裂强度问题；

• results show that the open porosities are decreased and fracture strength is increased with the increase of the sintering temperatures.

  结果表明；随着烧结温度的升高，开口气孔率降低，断裂强度升高。

• yield strength of in-situ mmcs is 28% and 95.7% higher, respectively than those of ex-situ mmcs and matrix aluminum, and fracture strength is increased by 20.6% and 88.5% correspondingly.

  原位复合材料的增强效果明显，屈服强度比外加复合材料和基体分别高出28%和95.7%，断裂强度则相应提高了20.6%和88.5%；

• conclusions are that the peeling strength can be effectively enhanced but the tensile fracture strength can also be affected to a certain extent.

  实验发现，通过对涤纶基材进行堿减量处理，可有效地提高其建筑膜材的剥离强度，但对拉伸断裂强度有一定的影响。

• the fracture strength of rectangular plate with inclined crack is analyzed considering two failure modes of elastic fracture and fully plastic failure respectively.

  对具有中心穿透斜裂纹在弹性断裂和完全塑性断裂两种破坏模式下的断裂强度进行了分析。

• for the green body containing a certain size of sic powders, the carbon particle should be less than a certain size, or else, the density and fracture strength of rbsc decrease wit…

  对于一定粒度的碳化硅粉而言，加入到生坯中碳粉粒度应小于一定尺寸，否则，陶瓷的断裂强度和密度将随碳粉粒度的增大而降低。

• the formula of the new fracture strength criterion of rocks with cracks is different for the two cases of close and open cracks in rocks.

  水对巖体断裂强度的作用，对于裂纹是否闭合，在新準则中有不同的表达式。

• methods 15 anterior ceramometal test full crowns were fabricated and 15 natural anterior teeth were selected. fracture strength were measured.

  制作15个前牙金瓷全冠，挑选15个离体前牙，测定其折裂时的强度。

• the real fracture strength is restrained by both stresses caused by outside load and residual stresses after grinding.

  实质断裂强度性能受到了外加载荷与磨削残余应力的组合应力的制约。

• fracture strength , fracture toughness and hardness were researched.

  此外，研究了材料的抗弯强度、断裂韧性和硬度。

• according to the fracture strength of rock, this paper discusses and analyzes the breaking mechanism of rock cut by means of static blasting technique.

  另外，从考虑巖石的断裂强度出发，讨论、分析了静态爆破技术切割巖石时的破坏机理。

• the results show that the fracture strength was associated with the volume fraction, diameter and length of micron-fibers, and elastic constants of fiber, matrix and composite.

  结果表明复合材料的宏观强度与亚微米纤维的直径和长度、以及亚微米纤维、基体、共晶陶瓷棒体的弹性常数有关。

• the sma plate with the high content of impurity have two-step fracture phenomenon, whose ultimate fracture strength is higher than the normal one, however, its plasticity is worse.

  杂质含量高的板材出现两次断裂现象，其最终断裂强度比普通板材高，但塑性差；

• the fracture strength of circular diamond film was measured by a burst pressure technique.

  利用压力爆破技术测量了圆形金刚石膜的断裂强度。

• conclusion the fracture strength of premolar teeth filled with light curing composite resin was higher than filled with amalgam after root canal therapy.

  结论根管治疗后用光固化树脂充填前磨牙的各类洞，牙体的抗折强度优于用银汞充填者。

• in this paper, the influence of the surface residual stresses of ceramics grinding on fracture strength has been studied.

  探讨了陶瓷磨削表面残余应力对断裂强度的影响。

• with no yielding up to its fracture strength of cfrp, the stress of cfrp at the maximum shear loading is found to be the key parameters in determining shear strength of the columns.

  由于碳纤维布无屈服现象，故达到最大荷载时碳纤维布的应力是确定加固后柱受剪承载力的关键参数。

• in this paper, the assessment criteria of fracture strength for main parts of capel in hoisting is presented, the determination of fracture toughness and some stress strength factor are given.

  介绍了连接装置关键零件——主拉桿和夹板的防脆断强度準则，给出材料断裂韧性的工程估算方法以及若干常见裂纹的应力强度应子计算式。

• the experimental results show that the fracture strength and strain first increase and then decrease with increasing the ti content, and reaching the maximum value when ti content is 5 at. %.

  试验结果表明，随ti含量增加，合金的断裂强度及断裂应变先增后降，在ti含量为5at。%时达到最大值。

• the effect of porosity on fracture strength of reaction-bonded silicon carbide with free silicon removed by heat treatment in vacuum at 1600℃ and 1800℃ is investigated.

  研究了真空热处理温度对反应烧结碳化硅材料显微组织和断裂强度的影响。结果表明：反应烧结碳化硅中的游离硅在1600℃、1800℃真空热处理过程中已全部去除；

• besides, minimum radius and radius ratio of particle, especially the latter, have adverse effects on fracture strength factors of rock.

  巖石颗粒最小粒径与颗粒半径比均对断裂强度因子有不利影响，且颗粒半径比的影响较大。